Jinan Lijiang Automation Equipment Co., Ltd. |
Verified Suppliers
|
|
Insulating glass wire automatic sealer, color can be customized, additional functions
Application
Set up the machine
Find two 1.5-by-1.5-meter aluminum strips of 9A insulating glass
With the production line as the benchmark, two glasses are roughly
aligned with the feeding section and the production line position
Put the suction cup into the feeding section and place the position
of the discharging section and the horizontal spacing of the
feeding section is 245-255
Install the machine head vertical beam
Connect electricity and gas installation accessories
Turn on the glass feed to adjust the v-belt so that the glass and
back wheel close together to correct the v-belt
Leveling the feed and production line
Leveling the feeding and discharging sections
Adjust the expansion of the machine head so that the detector
adjusts the distance between the head and the discharge section at
the edge of the glass
Adjust the position of the suction cup
The empty trial to test the position of the four sides of the
nozzle
With glue of commissioning
Debug the mechanical position of v-belt positive limit negative
limit and fix the limit switch;
Drive backward to the mechanical position close to the negative
limit of the v-belt. Then fix the v-belt zero detection switch at
this position and stop immediately after touching it.
Drive forward to the mechanical position approaching the positive
limit of the v-belt. Then fix the v-belt positive limit detection
switch in this position and stop immediately after touching it.hen
set the pressure on one side, two sides, three sides and four
sides, rotate the glue head to 0 degrees, 90 degrees, 180 degrees
and 270 degrees respectively. Input the corresponding percentage in
the interface of forced sticking. Push the glue nozzle by hand,
which feels like a spring, and the reference value is 35%, 15%, 35%
and 90%.Maintenance state, in the manual state, the moving plate is
in the working open position. Select maintenance open, keep
pressing until the board is fully open. Do effective support
between the press plate, or have a man on duty station, people can
enter between the two boards.
The second positioning distance of the first side of the three-layer glass, the larger the parameter, the less the glue nozzle sticks to the glass.If the location of the second cavity is not correct, the three-layer glass will be used for compensation.This parameter needs to be modified in case of error in line length measurement.After the first edge is applied, the nozzle is rotated 90 degrees. After scraping, the glass will go some distance in the direction of the input section.After applying the second edge, the nozzle will rotate 180 degrees. After scraping, it will drop down a bit.After applying the third edge, rotate the nozzle 270 degrees. After scraping, the glass will go some distance in the direction of the output section.
Max.glass size | 2500mm |
Min.glass size | 170mm*400mm (2000mm machine) |
Glass thickness | 12-56mm |
Working speed | 5-40m/min |
Air pressure | 0.6-0.8MPa |
Squeeze pressure | <350kg/m³ |
Plane angle | 6°- 9° |
Max glass weight | 400kg |
Voltage power | 380V 12kw |
Overall dimension | 8700mm*2000mm*3500mm |