5m/S Steel Pipe Ultrasonic Flowmeter For Chemical Solvents

Small Pipe Ultrasonic Flowmeter for Copper / Steel / PVC

I INTRODUCTION

ML-F8 is very unique in its structural design. It uses a circular magnetic steel to achieve automatic connection during installation.It takes only 2-3 minutes to complete the whole process from installation to measurement. It also adopts the current popular OLED display, which makes it easy to read in low light conditions.

ML-F8 is widely used in the production process for flow measurement and monitoring. The application of the product continuously and effectively controls the flow of the fluid, so as to improve the yield of the product and even save the input of the personnel, bringing benefits to the production enterprise.

II. FEATURES

• Clamp on type, no need to cut the pipe or do any other changes.
• No professional product knowledge required, installation and measurement can be done based on the guide.
• No moving parts or pressure changes involved, installation can be done without stop provide.

III. Working Principle

Ultrasonic flow meters use sound waves at a frequency beyond the range of hearing (typically 0.5, 1, or 4 MHz). This ultrasound signal is sent into a stream of flowing liquid by using wetted (insertion) transducers that make direct contact with the liquid or external (clamp-on) transducers that send the ultrasound through the pipe wall. Clamp-on ultrasonic flow meters allow users to measure the volumetric flow rate of a fluid in a pipe without having to penetrate the pipe which decreases installation and maintenance costs.

A typical transit-time ultrasonic liquid flow meter utilizes two ultrasonic transducers that function as both ultrasonic transmitter and receiver. The ultrasonic flow meter operates by alternately transmitting and receiving a burst of ultrasound between the two transducers by measuring the transit time that it takes for sound to travel between the two transducers in both directions. The difference in the transit time (∆ time) measured is directly proportional to the velocity of the liquid in the pipe.

IV. SPECIFICATION

Model: ML-F8

Velocity Range: 0.1 m/s ~ 5.0 m/s

Accuracy: ± 2.0%

Pipe Size: DN15,DN20,DN25,DN32,DN40,DN50

Data Storage: Daily, Monthly, Yearly Totalizer

Analog output: 4~20mA, Maximum load: 600Ω

Alarm output: OCT, Upper and lower limit alarm function (for option)

Communication: RS485,support Modbus communication protocol

Power Supply: 24VDC

Cable Length: 1.8m

Keypad: Four light touch buttons

Screen: OLED 128*64 screen display

Units: Metric and imperial units are available

Cubic Meters(m3), Liters(L),USA Gallons(GAL)/hour, USA Gallons(GAL)/min
Default unit setting: m3/h

Totalizer: Six bit digit

Piper Material: Stainless steel pipe, carbon steel pipe, PVC

Case Material: Aluminum alloy

Environment Temp.:0℃-50℃

Medium Temp.:0℃-50℃

IP Grade: IP54

V. PIPE SPECIFICATION

VI. INSTALLATION STEPS

VII. APPLICATIONS

ML-F8 also satisfies different clean fluid measurements: various acids, alcohols, chemical solvents,alcohol, beverage water, Coca-Cola water, etc.