Super Audio Frequency Induction Heating Machine of Annealing and Normalising Metals

Induction Annealing and normalising machine Description :
  Annealing
 In general, the main purpose of annealing heat treatment is to soften the steel, regenerate overheated steel structures or just remove internal tensions.

 It basically consists of heating to austenitizing temperature (800ºC and 950ºC depending on the type of steel), followed by slow cooling.

  Normalizing
  Normalization is an annealing process. The objective of normalization is to intend to leave the material in a normal state, in other words with the absence of internal tensions and even distribution of carbon. For the process the high temperatures are maintained until the complete transformation of austenite with air cooling.

  It is usually used as a post-treatment to forging, and pre-treatment to quenching and tempering.

  Induction is used in most applications of annealing and normalizing in compared to conventional ovens.

Induction Annealing and normalising machine advantages:
 

    Processed in line with control of parameters in real time
   Metallurgical results similar to those obtained in conventional ovens
   Less environmental pollution
   Increase energy efficiency
   Reduced processing time
   Ability to control the heat, temperature accuracy
   Ability to heat small areas without changing the characteristics of the rest of the part
  Cycle accurate and repetitive heat
  Reduction of surface oxidation
  Improved job environment
  Some related industries are tube and pipe, medicine, oil and gas and automotive.

Induction Annealing and normalising machine main techinicall

​

Model	SF-80KW
Voltage	3Ph,380V+/-10%,50-60HZ
Output current	120A
Oscillation frequency	10-30KHZ
Output power	80KW
Cooling water pressure	0.3 mpa
Cooling water temperature protecting point	50 degree celsium

​

POSITIVE FEEDBACK FROM CUSTOMERS:

OUR FACTORY PHOTOS:

Services

   The objective of ORD Care Services is to make easier your life when you finally start with the production responsibility using ORD products. We can help with the operation and maintenance tasks finding out how to maximize production/process quality and economical results.

ORD Customer Services organization is fully committed with the above objective keeping close to their customers during the whole life-span system, being proactively suggested for improvements on the application. Information data systems and well defined and stored documentation on your installation allow ORD Customer Services to trace, analyse and give solutions for your continuous production improvement.

ORD company provides you an international technical assistance network and the following services:

Start-up Service
  This service is always included with the supply of an installation to leave the system up and running as part of a project.

On-site production assistance
In order to guarantee a ramp up production and to learn through hands-on training, ORD technical experts can assist you during the initial production time period with the new installation.

Inductor Shop
  We repair and manufacture all kind of coils/inductors for the industry for which our equipment is intended (automobile, casting, pipe-welding, etc.). Each inductor in each customer is followed up to control its performance and durability in order to improve next units.

Preventive Maintenance
In today’s production systems it is increasingly important to reduce halts in production as far as possible, as well as requiring a good maintenance policy. ORD offers Preventive Maintenance Contracts to deal with all our supplies, adapting these to suit our customers’ requirements.

Contact to :techincal@ordheater.com for more information.