|
[China]
Trade Verify
Address: Room 202, Building 4-2, No. 539, Shibei Industrial Road, Dashi Street, Panyu District, Guangzhou, Guangdong
Contact name:Tessa Huang
Guangzhou HongCe Equipment Co., Ltd. |
|
Verified Suppliers
|
|
|
IEC 60745-2-5 Figure 110 IEC Test Equipment Test Probe B With 12mm Diameter
IEC60745-2-5 clause 19.101.2.4
For checking the accessibility of the cutting edge zone at the
front of the saw above the guide plate, the rigid test probe ‘b’ of
Figure 110 shall not contact the blade when the saw is set for a
90° cut and any depth of cut and the probe ‘b’ is centred with the
blade then advanced in any single plane perpendicular to the blade
and parallel to the guide plate, as specified in Figure 111. The
test is repeated with probe ‘b’ offset 13 mm to the right of the
blade centre and then offset 13 mm to the left of the blade centre.
Compliance is checked by inspection and measurements.
IEC Test Equipment
Standard: IEC 60745-2-5 : Particular requirements for circular saws, clause 19.101.2.4 and Figure 110
Application: This probe is applicable to checking the accessibility of the cutting edge zone at the saw above the guide plate.
Test sample: Circular saws IEC Test Equipment
Parameter:
| Probe length | 50mm |
| Probe diameter | 12mm |
| Probe material | Stainless steel |
Standard figure:
Picture for reference:
