Excavator Hydraulic Main Pump Seal Kit JCB210 SK200-6 SK200-8 EC210 SH200A5

Excavator Hydraulic Main Pump Seal Kit JCB210 SK200-6 SK200-8 EC210 SH200A5

Specification

Excavator Seal Kit

Boom Seal Kit

Arm Seal Kit

Bucket Seal Kit

Hydraulic Pump Seal Kit

Control Valve Seal Kit

Travel Motor Seal Kit

Rotary Motor Seal Kit

Center Joint Seal Kit

Track Adjuster Seal Kit

Pilot gear pump seal kit, etc.

Hydraulic Seal installation requirements

1. the hydraulic sealing gaskets and flange sealing surface should be clean
2. hydraulic sealing gasket diameter should be smaller than flange seal face outside and inside diameter should be slightly bigger than a pipe inside diameter
3. Sealing gasket pre-tightening force should not exceed the design rules
4. sealing asbestos gasket compression, it is best to use the torque wrench
5. Installing a sealing gasket, should be in order, in turn, tighten the nut
6. if there is any leakage, must be installed after antihypertensive treatment to replace or adjust the sealing gasket

Please pay attention to the following items when storing the seal

1. Please do not open the package when it is not needed.

Otherwise, the seal may be "dust" or "scratched".

2.  Please store in a place with low humidity and avoid direct sunlight.

Ultraviolet rays and moisture accelerate the deterioration of rubber materials and the dimensional change and deterioration of resin materials.

3.  When storing the opened product, please be careful not to allow foreign matter to adhere or mix in, and repackage it as it is as possible. Especially nylon will change its dimensions due to moisture absorption, so please keep it sealed.

4. Do not place near high temperature heat sources such as boilers and heaters. Rubber materials will deteriorate faster due to heat.