Suzhou Hengxie Machinery Co., Ltd |
|
HXE-13DLA Aluminium rod breakdown machine with Annealer , Double spoolers
I. Quick details
HXE-13DLA Aluminium rod breakdown machine with annealer is used to draw and anneal single bare aluminium wire from 9.5mm to 1.7mm-4.2mm.
II. Component
1. Pay-off shelf | 1 set |
2. HXE-13DLA Aluminium rod breakdown machine | 1 set |
3. HXE-TH350 Annealing machine | 1 set |
4. HXE-180 Tension controller | 1 set |
5. HXE-WF650 Coiler (Optional, Not concluded in the quotation) | 1 set |
6. HXE-SX630 Double spoolers | 1 set |
7. Electrical cabinet | 2 set |
8. Operation panel | 1 set |
9. Spare parts for One year | 1 set |
10. Gear Oil System (Pump,Cooler, others) | 1 set |
III. Parameter
1. Inlet wire diameter 9.5mm
2. Outlet wire diameter 1.7mm-4.2mm
3. Actual drawing & annealing speed 800m/min
4. Number of Dies 13
5. Drum speed ratio 1.25
6. Capstan Iron cast, With Tungsten Carbide surface, 650mm, 4 pieces
7. Machine frame Welded
8. Main motor AC 75KW, Fix speed motor 22KW
9. Spooler motor AC 11KW
10. Inverter Inovance Brand
11. Speed adjust by Inverters
12. Transmission by Gear&Triangle Belts
13. Cantilever type pay-off shelf
14. Free rod type traversing
15. Power source customized
16. Annealing voltage 60V
17. Annealing current 3000A
18. Annealing power 180KVA
19. Annealing type D.C. Three section annealing
20. Annealing speed control by Inverters , auto tracking the drawing speed
IV. Shipping & Installation
Shipping
There are two lifting rings on the drawing machine, four on then annealing machine.
Installation (See attached drawing)
According to the drawing, make the foundation.
When machine is in position, install bolts and adjust the center line.
When concrete is drying, adjust center line again and fix the bolts.
Adjust
Before adjusting, check and clean all parts.
V. Advantage and after-sale service
After-sale service
Warranty: after shipping, machine part one year, electrical parts six months
Under these situation mentioned, the Seller will not take responsibility, but if the Buyer agree, will charge fees accordingly to repair the machine.
A. Due to wrong operation while shipping.
B. Due to Buyer`s wrong preparation that may cause damage to the machine.
C. Due to Buyer`s wrong operation that may cause damage to the machine.
D. Not in the consuming part list.
E. After agreement are made for the shipping, for any damage, Buyer should inform Seller in letter form to repair in seven days, If beyond the dare, Seller shall take no responsibility.
F. For any other failures due to acts of God (such as lightning, typhoon, earthquake, riots, war, fire or flood) and other factors that will cause damage, Seller shall take no responsibility.
G. Seller guarantee provide long term support regarding the parts and teach. After warranty, will charge accordingly.