Hexcore®-FRP PP Honeycomb Panel

Fiberglass pre-immerged resin sheet (FRP ) as skin panel on both sides, PP honeycomb as core. Resin adopted is Epoxy or Phenolic .They are composited from high pressure and heating by aero technology. There are about 60% consumption in FRP skin, so composite panel is more lighter in weight meanwhile more stiffness comparing with cold lamination, in the latter there are only less than 30% fiberglass adoption in FRP skin.

The features of Hexcore® FRP PP honeycomb sandwich panel are light weight, high stiffness, sound damping, fire-retardant, quakeproof, insulation, and environmentally friendly.

FRP surface thickness from 0.5mm to 2mm made according to clients request. Most commonly application in practice is 1.5mm and 2.0mm.

UV-treatment, anti-slip surface, gel-coat treatment, painting treatment and so on can be made according to clients request. But because our lamination is heating lamination so Gel-coat or Painting treatment only can be made after composite panel finished so such treatment cost is higher than usually supplier. Considering such cost, we strongly suggest client select original skin or black skin, the cost is competitive.

Sandwich panel is widely applied in Marine as structural material such as hull, deck, bulkhead, tank, canopies and cases;

• In tooling as fabricating tooling and moulds;
• In trucks as truck wall, floor, ceiling, fairing, guard;
• In wind turbine act as blades, canopy housing and rotor hoods;
• In film sets and decorative market;
• In anti-corrosion to prevent and repair of metal and concrete surfaces;
• In chemical barrier to provide protection for tanks, pits, pipes and grates.
• In building as floor, ceiling, wall, partition-door