Active Member
|
[China]
Address: 3rd Floor, No. 13, Huiye Road, Tangjia Community, Fenghuang Street, Guangming District, Shenzhen，Guangdong, China
Contact name:Anne
Shenzhen Okaf Technology Co., Ltd. |
|
|
Robot /Vehicle Mounted Telescopic Mast 2.5 to 20m Pneumatic CCTV Camera Pole
Specification
• Available Extended height:2.5m to 20m can be customized. Head load capacity: 5kg to 120kg. Lifting is by air compressor(air pump)
• The material is high strength aluminum alloy T6 6063. The Tube surface treatment is Hard anodizing which is Which against corrosion, rust and acid rain. It can last longer time even the bad environment.
• The mast can either be locking, which each section locks into place once it reaches its maximum extension - designed for safety and long term use( do not lift down the mast), or non-locking where each section sits on cushion of air.
Working principle:
The system uses pneumatic theory.Its good self-locking performance
achieving reliable ,self-locking in any position improves the
safety of reliability. Pneumatic telescopic mast is a type of
elevation solution using compressed air to raise the central column
to its extended height.
What's the advantages of OKAF pneumatic telescopic mast ?
• Lightweight but high intensity. We use high intensity
aluminum alloy, the tubes is lightweight and very stable. The wind
resistance 8 degree could also work well.
• The function and working height can be customized according
to your requirements. Our professional technician team will help to
provide best solution for you.
• Widely application. The pneumatic telescopic poles are
widely applied to surveillance ptz camera elevation,tracking or
detection,communications emergency,base ans facility security,
intelligence gathering, sensor elevation and elevated antenna etc
• Convenient to operate. The pneumatic telescopic mast is
dual control by remote control and RS485 system control.
Fast lifting. Within 1 minute to raise the telecommunication
antennas, led lights,mobile surveillance PTZ Cameras and Lightning
protection rod.
Technical data
| Extended height | 2.5 m |
| Retracted height | 0.8m |
| Max diameter | 69 mm |
| Top payload weight | 15 kg |
| Number of section | 3 |
| Items | Test condition |
Anti-wind capability | Level 8 wind: work normally; level 12 wind: can not be destroyed (working condition, nailed into the ground, 3-4 guy wires, pull angle: 30-40 degrees, the guy wire is tight). GJB74A-1998 3.13.13 |
| Low tempertaure storage | -55° |
| Low tempertaure working | -40° |
| high temperature storage | 70° |
| high-temperature working | 55° |
| Humidity | less than 90%(temperature 25°) |
| Exposed to the rain | Strength 6mm/min, the time of duration is 1 hour |
| Antiseptic | Refer to GJB150.11A-2009 Standard test |
| Dust-proof | Refer to GJB150.12.1986 Standard test |
| Solar radiation | Refer to GJB150.7.1986 Standard test |
| Mould | Refer to GJB150.2.1986 the second chapter standard inspection. Mildew-growing level: level 1 |
| Operating | Pneumatic Mast |
| Level of rotation speed | 6r/min |
| Wind Power | 66Km/h |
| Material | aluminium alloy |
| Security | Self-locking at any height; would not fall at any time |
Application
Telescopic mast are widely applied to military, communications,
police, fire truck and so on.
1. Radio installation Surveying
2. Temporary communications.
3. Emergency services (Light tower for fire fighting rescue)
4. Mobile surveillance ( PTZ camera for law forensics)
5. Semi-permanent Installations for outdoor Events(Military or
patrol surveillance)
6. Construction site surveillance(construction sites monitoring)
7.Wi-Fi antennas.
8. Mobile solar trailer & mobile light tower.
