|
[China]
Trade Verify
Address: NO.12 HUANGHE RD ,HUANGJINAG , DONGGUAN, GD,CHINA
Contact name:David
VEDALI HARDWARE CO., LTD |
|
Verified Suppliers
|
|
|
RAL 9010 Plastic Injection Mold Cable Wire Holder White With 3 Feet
Special designed injection molding multiple holder parts for wire assemblies , it was comprised of holder holes and feet , three holder feet are riveted into piece to fix holder ; Dozens of holes with gap that are placed one by one but are not crossed each other , these holes with different diameters for different diameter wires assembly .
Basic Information for Injection Molding Multiple Holders
Material : PA 66
Color : White RAL 9010
Length : 90mm
Width : 10 mm
Height : 18 mm
No. of Feet : 3
Fixing Method :Riveting
Dismantled or not : non-dismantled
Mechanical Property for injection Molding Multiple Holders
| Tensile strength MPa | 70 |
| Elongation at break % | 40 |
| Bending strength MPa | 90 |
| Modulus of elasticity for tension MPa | 3160 |
| modulus of elasticity for bending MPa | 2880 |
| Compressive strength MPa | 127 |
| Shearing strength MPa | 67 |
| Notched Impact Strength(J/m) | 76 |
| HR hardness | 94 |
| Fatigue MPa | 35 |
Electrical Performance for injection Molding Multiple Holders
| Specific volume resistance Ω·cm | 10 |
| Specific inductive capacity(10Hz) | 3.8 |
| Dielectric loss tangent (10Hz) | 0.005 |
| Dielectric strength(kV/mm) | 20 |
| Arc-resistances | 220 |
Thermal Performance for injection Molding Multiple Holders
| Heat distortion Temperature(1.82MPa)℃ | 110 |
| Normal working temperature ℃ | 80 |
| Working temperature arrange ℃ | -40℃～90℃ |
| Coefficient of linear expansion (×10K) | 7.5 |
| Heat conduction W/(m·K) | 0.23 |
Attentions for Use
POM injection molding holder parts are easy to be cracked and pulverized outside long-term .
Don’t put POM injection molding holder parts under temperature over 100℃
Don’t put POM injection molding holder parts under circumstance with alkali and oxidant .
RFQs for injection Molding Multiple Holders
Are you able to develop customized injection molding holder parts ?
Yes , we are in this filed over 10 years and expert for customization .
How long for developing a new injection mold?
Normally , one week .
What materials you can handle for plastic injection molding parts ?
Like usual materials PA , PC ,ABS ,PE ,PP , PMMA and Rubber .
