CE FFP2 Horizontal Foldable Mask , FFP2 Dust Mask , With Carbon
With Valve
1 . Descriptions
MX-3006 FFP2V Dust Mask with 4-ply non-woven/elasticated strap ,fold flat dust mask ,convenience take/packing:
neutral color box, also can OEM/disposable dust mask with
valve/protect against dust and liquid
Active carbon is better for odour and hot working condition.
2 . Material of each layer
1st layer : Protective pp spun-bonded non-woven
2nd layer : Active carbon filter(MX-5006)
3rd layer : FFP2 melt blown filter(have filter efficiency level of
94%)
4th layer : Shaped needle punched cotton
3 . How to use?
- Cup respirator in one hand with nosepiece at fingertips,allow
headbands to hang freely below hand.
- Hold respirator under chin,with nose piece up
- Locate the upper strap across the crown of the head and the lower
strap below the ears.
- Strap must not be twisted
- Using both hands,mould nose clip to the shape of the lower part of
the nose to ensure a close fit and good seal.Pinching the nose clip
using only one hand may result in less effective respirator
peformance.
- The seal of the respirator on the face should be fit-checked before
entering the workplace.
- If the user feels the bottom strap is too loose and it is not
possible to achieve a satisfactory fit of the mask a knot can be
tied in the strap.
4. Warning
- The user should be trained in the fitting and should be aware of
the instructions for using prior to donning the respirator.
- Use in adequately ventilated areas,which are not deficiency of
oxygen.
- Do not use this respirator when oxygen concentration is less than
19.5%.
- Do not use the mask in explosive environment.
- The mask must be fitted correctly to ensure the level of protection
expected is achieved.
- The facila hairs or heards and certain facial charactrtistics may
reduce the effectiveness of the mask.
- For mask mark marked “NR”,the particle filtering half mask shall
not be used for more than one shift.
5. Certification
This product has been tested according to the following European
Standard:
- EN149: 2001 +A1: 2009. Respiratory protective devices. Filtering
half masks to protect against particles. Requirements, testing,
marking.It complies with European Regulation (EU) 2016/425 on
Personal Protective Equipment (PPE).Category III.
- EU type examination certificate (module B) issued by BSI , notified
body n°0086.The PPE is subject to the conformity assessment procedure based on
internal production control plus supervised product checks at random intervals (Module C2) set out in Annex VII under
surveillance of BSI , notified body n°0086.
6.Discard and replace the mask if:
- The mask is removed whilst in the contaminated area.
- Clogging of the respirator causes breathing difficulties.
- The mask becomes damaged.
- For respirators protecting against vapours,the smell of vapours
present becomes derectable.
7. More pictures
