Horizontal Swimming Pool Dosing Pump , Durable Swimming Pool Submersible Pump

Swimming Pool Dosing Pump Pool Pump Pot Submersible Pump For Swimming Pool

Features:

1. Excellent Flow rate suitable for spas and pools up to 2000 litres

2. Suitable for spas including Salt, Chorine, Inground and Above Ground

3. Corrosion Resistant and Chemical-resistant thermoplastic body

4. Tough durable construction for longer lasting life

5. Built-In Thermal Protection

6. Instruction manual for ease of installation and use.

7. Anti spin-off impeller.

8. A large see-through strainer, super-size debris basket.

9. Special design shockproof basement

INSTALLATION
Only qualified licensed electrician should install pump and wiring.
IMPORTANT ELECTRICAL
Electrical Contractors Please Note: All 220/380 Volt 50Hz pumps must be wired to the main power
supply through an approved and correctly rated electrician.
PUMP MOUNT MUST
Be solid Level Rigid Vibration Free.
Allow use of short, direct suction pipe. (To reduce friction losses & don’t install the pump more
than 3M geometrical height from water level)
Allow for gate valves in suction and discharge piping.
Have adequate floor drainage to prevent flooding.
Be protected from excess moisture.

All adequate access for servicing pump and piping.

A smart pump controller packed with great specifications and features that make it perfect. Everything is made easy where it automatically switches your pump on/off on open/closing of any tap. It comes with a LED screen showing the live RPM, current, voltage, etc. It provides stable performance, requires low maintenance and is long lasting; it is one of the few that will exceed your expectations. Buy one today and have the best and most reliable equipment at hand.

Ÿ Be solid Level Rigid Vibration Free.
Ÿ Allow use of short, direct suction pipe. (To reduce friction losses & don’t install the pump more
than 3M geometrical height from water level)
Ÿ Allow for gate valves in suction and discharge piping.
Ÿ Have adequate floor drainage to prevent flooding.
Ÿ Be protected from excess moisture.
Ÿ All adequate access for servicing pump and piping.
NOTICE
Pump suction and discharge connections have moulded in thread stops, DO NOT try to screw pipe
in beyond these stops.
OPERATION
NEVER run pump dry! Running pump dry may damage seals, causing leakage and flooding! Fill
pump with water before starting motor.
Before removing lid:
STOP PUMP before proceeding.
CLOSE GATE VALVES in suction and discharge pipes.