High Speed 3d Printer Filament Extruder Machine 1.75mm / 2.85mm / 3mm Diameter

1.75mm 3mm ABS Plastic 3D Printer Filament Machine For 3D Printing

ABS (Acrylonitrile butadiene styrene) is an oil based filament and has a higher melting point than PLA. ABS filament is commonly used in 3D printing. It has the following characteristics:

• Softer than PLA, but high strength, good toughness;
• Density is small, when printing larger volume model lighter, save money;
• Cost-effective, can be processed in wide range temperature;
• Accurate diameter: 3.0/1.75mm, variations + /-0.05mm, roundness +/-0.03mm;

1. Big capacity compared with other suppliers using the same model.

2. Lowest tolerance: +/- 0.03 mm. even +/- 0.02 mm.

3. Both 1.75 and 3.00mm filament diameter.

4. It can process multi-materials like PLA ABS PET PA HIPS .

5. Easy operation: SIEMENS PLC full-auto controling system.

6. Stable quality , we have not received any passive talks from our customers.

7. Oversea service, installation, staff trainning and technical support.

Application:

With the rise of 3D printing technology,3D printer has been used by designers, engineers and scientists to produce the disposable mechanical products and model, and it is already widely used in health care, education, toys, building, automobile, electronics, and anime field.

Technical:

1. The vacuum loader wil help load the raw material into the hopper dryer,which will help reduce labor. Thehopper dryer is with heating and blowing drying system which will help fully dry the raw materials.

2. The whole machine is controlled by on touch screen PLC system. The PLC system will automatically control all other systems according to the data from the roundness laser measuring device. If the roundness tolerance is too big,the system will automatically control the cooling water temperature,extrusion speed and tracting speed.

3. The tractor machine uses soft belt , which will ensure that the filament will not change shape and the storage thread stand is very important for leaving enough time to change the spool.