Active Member
|
[China]
Address: R1811, B Bldg, Jiahe Tower, No.3006 Shennan Mid Rd, Shenzhen, China
Contact name:CXDA-FPGA
CHUANGXINDA ELECTRONICS-TECH CO., LIMITED |
|
|
OPA2335AIDR Op Amps Single SOIC-8 Operational Amplifier Chip
| Product Attribute | Attribute Value |
|---|---|
| Texas Instruments | |
| Operational Amplifiers - Op Amps | |
| SMD/SMT | |
| SOIC-8 | |
| 2 Channel | |
| 5.5 V | |
| 2 MHz | |
| 1.6 V/us | |
| 0.005 mV | |
| 2.7 V | |
| - 40 C | |
| + 85 C | |
| 200 pA | |
| 285 uA | |
| No Shutdown | |
| 110 dB to 130 dB | |
| OPA2335 | |
| Cut Tape | |
| MouseReel | |
| Reel | |
| Amplifier Type: | Low Offset Voltage Amplifier |
| Features: | EMI Hardened, Zero Drift |
| Height: | 1.58 mm |
| Input Type: | Rail-to-Rail |
| Length: | 4.9 mm |
| Output Type: | Rail-to-Rail |
| Product: | Operational Amplifiers |
| Supply Type: | Single, Dual |
| Technology: | CMOS |
| Width: | 3.91 mm |
| Brand: | Texas Instruments |
| In - Input Noise Current Density: | 0.02 pA/sqrt Hz |
| Maximum Dual Supply Voltage: | +/- 2.75 V |
| Minimum Dual Supply Voltage: | +/- 1.35 V |
| Moisture Sensitive: | Yes |
| Operating Supply Voltage: | 2.7 V to 5.5 V, +/- 1.35 V to +/- 2.75 V |
| Product Type: | Op Amps - Operational Amplifiers |
| PSRR - Power Supply Rejection Ratio: | 120 dB |
| Factory Pack Quantity: | 2500 |
| Subcategory: | Amplifier ICs |
| Vcm - Common Mode Voltage: | Negative Rail - 0.1 V to Positive Rail - 1.5 V |
| Voltage Gain dB: | 130 dB |
| Unit Weight: | 0.002677 oz |
The OPA334 and OPA335 series of CMOS operational amplifiers use
auto-zeroing techniques to simultaneously
provide very low offset voltage (5µV max), and near-zero drift over
time and temperature. These miniature, high-precision,
low quiescent current amplifiers offer high input impedance and
rail-to-rail output swing. Single or dual supplies as low as
+2.7V (±1.35V) and up to +5.5V (±2.75V) may be used. These op amps
are optimized for low-voltage, single-supply
operation.
The OPA334 family includes a shutdown mode. Under logic control,
the amplifiers can be switched from normal operation
to a standby current of 2µA. When the Enable pin is connected high,
the amplifier is active. Connecting Enable low
disables the amplifier, and places the output in a highimpedance
state. The OPA334 (single version with shutdown) comes in
MicroSIZE SOT23-6. The OPA335 (single version without shutdown) is
available in SOT23-5, and SO-8.
The OPA2334 (dual version with shutdown) comes in MicroSIZE
MSOP-10. The OPA2335 (dual version without shutdown) is
offered in the MSOP-8 and SO-8 packages. All versions are specified
for operation from –40°C to +125°C.
