Active Member
|
[China]
Address: 189# Longzhen Road,Cixi City,Ningbo,Zhejiang Province,China
Contact name:Kevin
Ningbo FET Building Materials and Technology Co.,Ltd |
|
|
Heat Insulation Water and Damp Proof UV Coated 100% Non-asbestos Cellulose Wall Cladding Fiber Cement Sheet Decorative
Main Features:
1. Fire-proof:Incombustible A1,the boards not burning in firesite, won't produce any poisonous
gas.
2. Damproof: In the open air, high humidity environment, the board still can
keep stable performance.
3. Sound & heat insulation: low heat conductivity, good heat
insulation.
4. High strength: Not cracking, not broken, good impact resistant.
5. Safe, non-toxic, non-radioactive,
6. Secondary processing with good performance: can be cutting, drilling, carving,
Product Introduction:
Fiber cement board is a composite material made of sand,cement and
cellulose fibers. Fiber cement board is manufactured in a sheet
form and is used not only as cladding but also commonly used as an
eave lining and as a tile underlay on decks and in bathrooms and
other places.
Product | Normal Fiber Cement Board |
Dry Density(g/cm3) | 1.2-1.3 |
Water absorption (%) | 33-40 |
Wet expansion (%) | 0.25 |
Water Content(%) | 13-20 |
Bending Strength(Mpa) | 9-16 |
Shrinkage rate(%) | 0.15-0.2 |
Frost resistant | No delamination and crack after 25cycles under freezing and thawing |
Water penetration | No water drop on the board surface after 24hours |
Product Application:
Specification:
(1). Thickness: 4-25mm
(2). Standard size: 1220*2440mm or 1200*2400mm
(3). Note: other specification is available
Packing:
1. Strong wooden pallet(Standard Export Package)
2. Corner protective
3. Plastic Film
4. Protect Board
Partition Installing Method:
1. Galvanized Metal Frame
a. The top and bottom keels are fixed respectively top floor and on
floor with expansion bolts.
b. The vertical keel should be aligned well according to the
requirement (generally being 612 mm) with
laterally supporting keel installed.
2. Board Material Package Fixed
a. Cutting the board material to the dimensions needed (about 10mm
lower than wall height)
b. Board material is fixed on keel in anchoring seam way with
tapping screw: the interval of tapping screw is generally
about 200~250mm with screws sinking 0.5mm under the board face.
c. The expansion seam of about 4mm between boards should be kept.
d. The shrouding should be fixed from the middle to the four sides
and cannot be operated at multipoint simultaneously
to avoid generating inner stress to make board material bucking.
e. Before board being packaged and fixed, depending the needs,
glass cotton or rock cotton can be filled.
