Active Member
|
[China]
Address: No. 40 Gaoxinsi road, Donghu high-tech zone, Wuhan, 20 buildings 4003, Gezhouba solar city
Contact name:Guoshou Fu
Wuhan Ouyi Optoelectronic Technology Co., Ltd. |
|
|
10G SFP+ Module Simplex LC BIDI 60KM 1270nm/1330nm Fiber Channel Module
Applications
10GBASE-LR/LW
CPRI rates 6.144Gb/s, 9.83Gb/s
10Gb/s Fiber Channel
1. pluggable
2. 10Gb/s serial optical interface
3. Up to 60km distance
4. Compliant with SFP+ MSA
5. SFP MSA package with Simplex LC connector
6. Digital Diagnostic Monitor Interface
7. Very low EMI and excellent ESD protection
8. High transmission margin
9. 3.3V single power supply
10. Below 1.5W power consumption
11. SFP mechanical interface
12. Wide data-rate range
PRODUCT DESCRIPTION
SFP+10G-LR modules Complaint with IEEE 802.3ae 10GBASE-LR,Electrical interface
compliant to SFF-8431 specifications for enhanced 8.5 and 10
Gigabit SFP module “SFP+”,1270nm DFB transmitter, PIN
photo-detector,LC connector,2-wire interface for management specifications
compliant with SFF 8472 digital diagnostic, Compliant with SFF8472
Digital Diagnostic Standard(DDM)
The SFP+ LR module electrical interface is compliant to SFI electrical specifications. The transmitter input and receiver output impedance is 100 Ohms differential. Data lines are internally AC coupled. The module provides differential termination and reduce differential to common mode conversion for quality signal termination and low EMI. SFI typically operates over 200 mm of improved FR4 material or up to about 150mmof standard FR4 with one connector.
Optical Characteristics (TOP=25°C, Vcc=3.3 Volts)
| Parameter | Symbol | Min | Typ | Max | Unit | Ref. |
| Transmitter | ||||||
| Output Opt. Power | PO | 0 | 5 | dBm | ||
| Side-Mode Suppression Ratio | SMSR | 30 | dB | |||
| RMS Spectral Width(-20dB) | σ | 1 | nm | |||
| Optical Extinction Ratio | ER | 3.5 | 4.5 | dB | ||
| Tx Jitter(SONET)20KHZ-80MHZ | Txj1 | 0.3 | UI | 3 | ||
| Tx Jitter(SONET)4MHZ-80MHZ | TXj2 | 0.1 | UI | 3 | ||
| Path penalty at 800ps/nm@9.95Gb/s | 2 | dB | ||||
| Relative Intensity Noise | RIN | -128 | dB/Hz | |||
| Center Wavelength | λc | 1260 | 1270 | 1330 | nm | |
| Receiver | ||||||
| RX Sensitivity @10.3 Gb/s | SENS | -16 | dBm | 1,2 | ||
| Receiver Overload | -1 | dBm | ||||
| Optical Center Wavelength | λC | 1320 | 1330 | 1340 | nm | |
| LOS De-Assert | LOSD | -18 | dBm | |||
| LOS Assert | LOSA | -30 | dBm | |||
| LOS Hysteresis | 0.5 | dB | ||||
Notes:
1. Measured with conformance signals defined in FC-PI-2 Rev. 10.0 specifications.
2. Measured with PRBS 231-1 at 10-12 BER.
3. GR-253-CORE Issue 4.
4. With optical input power at the receiver between -1 ~ -11dBm
Recommended Operating Conditions
| Parameter | Symbol | Unit | Min | Typ | Max |
| Storage Temperature Range | Ts | ℃ | 0 | 70 | |
| Power Supply Voltage | Vcc | V | 3.135 | 3.3 | 3.465 |
| Data Rate | Gb/s | - | 10 | - |
