Active Member
|
[China]
Address: No. 40 Gaoxinsi road, Donghu high-tech zone, Wuhan, 20 buildings 4003, Gezhouba solar city
Contact name:Guoshou Fu
Wuhan Ouyi Optoelectronic Technology Co., Ltd. |
|
|
10G Ethernet 20KM SFP+ Optical Transceiver Module TX1330nm DFB RX1270nm LC BIDI
PRODUCT DESCRIPTION
The SFP+10G modules offer customers a wide variety of 10 Gigabit Ethernet connectivity options for data center, enterprise wiring closet, and service provider transport applications.It is a mallest 10G form factor Supports 10GBASE Ethernet and OTU2/OTU2e .
The SFP+ module electrical interface is compliant to SFI electrical specifications. The transmitter input and receiver output impedance is 100 Ohms differential. Data lines are internally AC coupled. The module provides differential termination and reduce differential to common mode conversion for quality signal termination and low EMI. SFI typically operates over 200 mm of improved FR4 material or up to about 150mmof standard FR4 with one connector.
SFP+10G modules Complaint with IEEE 802.3ae 10GBASE-LR,Electrical interface compliant to SFF-8431 specifications for enhanced 8.5 and 10 Gigabit SFP module “SFP+”,1330nm DFB transmitter, PIN photo-detector,LC connector,2-wire interface for management specifications compliant with SFF 8472 digital diagnostic, Compliant with SFF8472 Digital Diagnostic Standard(DDM)
Applications
10GBASE-LR at 10.3125Gbps
10GBASE-LW at 9.953Gbps
10GBASE-BX
Other Optical Links
PRODUCT FEATURES
Digital Diagnostic SFF-8472 Compliant
Operating case temperature:
Standard: 0 ~ 70 °C
Supports 9.95Gb/s to 10.3Gb/s data rates
Up to 20km on 9/125um SMF
1330nm DFB Laser transmitter,1270nm receiver
SFP+ MSA SFF-8431 Compliant
Simplex LC Connector Bi-Directional SFP+ Optical Transceiver
Single 3.3V Supply
Spec
| Parameter | Symbol | Min | Typ | Max | Unit | Ref. |
| Transmitter | ||||||
| Output Opt. Power | PO | -6 | 1 | dBm | ||
| Side-Mode Suppression Ratio | SMSR | 30 | dB | |||
| RMS Spectral Width(-20dB) | σ | 1 | nm | |||
| Optical Extinction Ratio | ER | 3.5 | 4.5 | dB | ||
| Tx Jitter(SONET)20KHZ-80MHZ | Txj1 | 0.3 | UI | 3 | ||
| Tx Jitter(SONET)4MHZ-80MHZ | TXj2 | 0.1 | UI | 3 | ||
| Path penalty at 800ps/nm@9.95Gb/s | 2 | dB | ||||
| Relative Intensity Noise | RIN | -128 | dB/Hz | |||
| Center Wavelength | λc | 1320 | 1330 | 1340 | nm | |
| Receiver | ||||||
| RX Sensitivity @10.3 Gb/s | SENS | -14 | dBm | 1,2 | ||
| Receiver Overload | -1 | dBm | ||||
| Optical Center Wavelength | λC | 1260 | 1270 | 1280 | nm | |
| LOS De-Assert | LOSD | -17 | dBm | |||
| LOS Assert | LOSA | -30 | dBm | |||
| LOS Hysteresis | 0.5 | 2 | 6 | dB | ||
Notes:
1. Measured with conformance signals defined in FC-PI-2 Rev. 10.0 specifications.
2. Measured with PRBS 231-1 at 10-12 BER.
3. GR-253-CORE Issue 4.
4. With optical input power at the receiver between -1 ~ -11dBm
| Parameter | Symbol | Min. | Typ. | Max. | Unit | Notes |
| Maximum Supply Voltage | Vcc3 | -0.5 | - | 4.0 | V | |
| Storage Temperature | TS | -40 | - | 85 | °C | |
| Operating Humidity | - | 5 | - | 95 | % | |
| Maximum Supply Voltage | Vcc3 | -0.5 | - | 4.0 | V |
| Parameter | Symbol | Min. | Typ. | Max. | Unit | Notes |
| Power Supply Voltage | Vcc | 3.13 | 3.30 | 3.47 | V | |
| Power Supply Current | Icc | - | - | 300 | mA | |
| Case Operating Temperature | Top | 0 | - | 70 | °C | |
| Data Rate | - | - | 10.3125 | - | Gb/s | |
| 9/125um G652 SMF | Lmax | - | - | 20 | Km |
