Active Member
|
[China]
Address: 33 North Street, High-tech Industry Development Zone, Xi 'an City, Shaanxi Province, China.
Contact name:
Xi'an Noker Electric Co.,Ltd. |
|
AC380V Thyristor Multi-protection High Torque Electronic Soft
Starter 220KW Asynchronous For Electric Motor
Features
1. Voltage control type and current limiting type
2. Digital and single chip control
3. Human-machine interface available
4. Space saving thanks to natural cooling with small housing design
5. Protection function: over voltage, over current, over load, over
heat, short circuit, lower voltage, input or output phase failure,
three phase imbalance, starting time over long protection etc.
6. Customization is available for specified application and
requirement
Conditions Of Usage
| Item | Description |
| Power supply | AC220V/380V/660V±15% |
| Power frequency | 50/60Hz |
| Adaptive Motor | Squirrel-cage three-phase asynchronous motor |
| Starting times | It is recommended not to exceed 20 times per hour |
| Control mode | 1) Operation panel control; 4) External control+ COM control ; 7) COM control ; |
| Start Mode | 1) Current-limiting start; 4) Torque control +voltage ramp to start; |
| Stop Mode | 1) Soft stop; 2) Free stop; |
Protective Function | 1) Open loop protection for external instantaneous stop terminals; 2) Over-heat protection for soft starter; 4) Input open phase protection; 7) Starting over current protection; 10) Overvoltage protection for power voltage; 13) Auto restart or incorrect wiring protection; |
| Protection Class | IP00,IP20 |
| Cooling Pattern | Natural wind cooling |
| Place to be used | Indoor location with good ventilation free from corrosive gas and conductive dust. |
| Environment Condition | Below 2000M. Rise the rate power when the altitude is more than
2000M. Ambient Temperature -25+45°C Ambient Humidity 95%(20°C±5°C) Vibration<0.5G |
Connection Diagram
Dimension
Maintenance
1. Dust: If too much dust, it will reduce the insulation level of
the soft starter, even causes the soft starter does not work.
Brush the dust with clean and dry brush.
Remove dust with compressed air machine.
2. Condensation: If condensation, it will reduce the insulation
level of soft starter, even causes the soft starter does not work.
(1) Blow it with a hair dryer or electric stove.
(2) Bring it to power distribution room for dehumidification.
3. Regularly check components' intact. Whether it can work
properly.
4. Check soft starter' cooling channel, ensure they are not clogged
by dirt and dust.
Before maintenance checking, it has to cut off all power in the
line side of soft starter.
