NovotechnikM U k 3 5 0

Special features
* Interface module for position
sensors
* Aluminium die-cast housing;
Protection class IP 66
* standardized output signals
0 ... 10 V
± 10 V
0 ... 20 mA
4 ... 20 mA
* outstanding linearity
* extremely low temperature
drift 30 ppm/K (typical value)
* zero point and range adjustable
The signal conditioner supplies
the position sensors with
a highly stable constant voltage.
The wiper signal is picked
off without load via a highresistance
input stage and
transformed into a displacement
or rotationally proportional
standardized output signal.
The excellent linearity, low
temperature drift and sensorproximity
of the signal conditioning
process ensure full
utilization of the outstanding
benefits of the position sensors,
guaranteeing the reliable,
interference-free transmission
of signals even over long
distances.
The zero point and range can
be adjusted independently of
each other within wide limits
using spindle trimmers. This
facility permits standardized
output signals to be adjusted
even if the maximum stroke /
angle of the sensor is not
completely utilized. The electronic
circuitry is accommodated
in an aluminium die-cast
housing conforming to protection
class IP 66. The UNI-sealed
threaded joint ensures a
correct EMC coupling of the
cable shield. The wide operating
voltage range allows the
unit to be supplied with an
unstabilized direct voltage
source. Selected SMD components
with a wide temperature
range guarantee maximum
operating reliability even
under extreme environmental
conditions.
The MUK 350 is connected
by means of a four-pole terminal
strip.
M U k 3 5 0