Home Companies Guangzhou Comax Communication Co.,Ltd.

1000Base-TX/FX Ethernet Optic Fiber Media Coverter/Transceiver

Guangzhou Comax Communication Co.,Ltd.
Active Member

Contact Us

Address: Room 2005,Building B,Shiqiao Industrial Area,Panyu District,Guangzhou City,China

Phone: 86-20-29836698

Contact name:Ms. Eva Yang

Inquir Now

Guangzhou Comax Communication Co.,Ltd.

1000Base-TX/FX Ethernet Optic Fiber Media Coverter/Transceiver

City & Province Shenzhen Guangdong
InquireNow

Product Details

Description:1000Base-TX/FX Ethernet Optic Fiber Media Coverter/Transceiver 

 

INSTALLATION
1.
Interface
RJ-45 interface
The transmission media adopts CAT5 twisted-pair with typical length of 100 meter. It features the function of automatically identifying the through line and cross wire  
Fiber interface
SC/ST fiber interface is of duplex mode type, including two interfaces, namely TX and RX. When the two sets of optical transceiver are interfaced or connected to switch with fiber interface, the fiber is in cross connection, namely "TX-RX", "RX-TX" (direct butting for single optical fiber).
2.
Connection
The network device (work station, hub or switch) with RJ-45 interface is connected to RJ-45 jack of optical transceiver through twisted-pair. And the multi/single mode fiber is connected to SC/ST fiber interface of the optical transceiver. Then switch on. The corresponding LED is on for correct connection. (See the table below for the LED indicator lamp)

 

TECHNICAL PARAMETERS
1. Standard Protocol:
  IEEE802.3 10 Base-T standard
  IEEE 802.3u 100Base-TX/FX standard
  IEEE 802.3z 1000Base-TX/FX standard
2. Connector:oneUTPRJ-45connector,oneSC/STconnector
3. Operation mode: full duplex mode or half duplex mode
4. Power supply parameter:
   outside: 5V DC 2A
   built-in: 110-265V AC  48VDC

5. Environmental temperature: 0~60°C

6. Relative humidity: 5%-90%
7. TP cable: Cat5 UTP cable
8. Transfer fiber:
  multi-mode: 50/125, 62.5/125 or 100/140μm
  single mode: 8.3/125, 8.7/125, 9/125 or 10/125μm

 

Working environment 

Working temperature: -10°C ~ 50°C
Working Humidity:        5%~95 % (no condensation)

 
Installing the Converter

Wear a grounding device for electrostatic discharge

Install the media cable for network connection

Verify that the voltage of AC power is correct and plug in AC power cord

Hot Products

Description:1000Base-TX/FX Ethernet Optic Fiber Media Coverter/Transceiver INSTALLATION 1. Interface ...
Fiber Optical Splitter PLC 1*16 SC Connector 1X16 PLC fiber optic splitter 1) Low insertion loss,low ...
16CH CWDM Fiber Optic Equipment 20nm Channel Separation 1.High Isolation; 2. Low insertion Loss; 3...
1*16 PLC Fiber Optical Splitter Box 1.Low insert loss and high return loss 2.High reliability and ...