Active Member
|
[China]
Address: NO11,Changchun Road, Hi-tech Zone Zhengzhou,China
Contact name:doritdental
Henan Dorit Biotechnology Co., Ltd. |
|
|
Dental Contra Angle Handpiece Features
1. External water spray
2. Materials: aluminum; Bearing: Japan imported stainless steel
3. Chuck type: latch chuck
Dental Contra Angle Handpiece Technical Data
| Speed ratio | 1:1 |
| Working air pressure | 0.3~0.35 Mpa |
| Max rotation speed | 22,000rpm |
| Bur applicable | Φ2.33~2.35mm |
| Noise | ≤70DB |
Dental Contra Angle Handpieces Details
Company imformation
Henan Dorit Biotechnology Co., Ltd is located in the National University Science Park of Hi-Tech Development Zone, Zhengzhou, Henan Province. Dorit is an innovative company which is focus on R&D, manufacture and sales of dental products. Our target is“share wealth with the world;Soul moisten in the dental profession” We are adhering to the company’s mission "Quality assurance is the responsibility, Technology is the advantage, Innovation leads the future", and implement these philosophies to the company’s management, product R & D and manufacturing. Dorit Company continues to absorb high-grade, precision and advanced talents to integrate related industry resources in order to offer better and more comprehensive services to the society.
After each patient use , maintenance should be done as follows:
1. First remove the diamond burs , and clean up all the teeth on dental handpieces precipitate
2. Use a metal needle to clean the spray holes and fumaroles
Note: The spray holes and diamond burs into 40 -degree angle , fumaroles and diamond burs to a 30 degree angle
3. Place the clean lubricating oil is sprayed into the axial hole 1-2 seconds ( diamond burs is plugged holes )
4. In the bottom of the handpiece were ( with / without quick connector ) two kinds of styling , make the right amount of lubricant is injected into the bottom
5. The handpiece with quick connector combination ( first determine the water switch is turned off )
6. Replace the diamond burs , surrounded by white silk cloth handpiece head ( make sure the needle does not touch the diamond burs and white gauze , so as not to tie )
7. pedal depressed for about 20 seconds , look at whether there is in white gauze on any stain. If there are stains on the white gauze , again, add oil , starting from item 4 continued routine maintenance , know that white gauze until no stain
8. Finally, no more than 135 degrees Celsius temperature and high pressure sterilization
