Plasma Nozzle 120934 , Plasma Cutting Machine Parts

Plasma Nozzle 120934, Plasma Cutter Machine, Plasma Accessories
 
Shanghai ZhouBo Welding & Cutting Technology company can supply various models of plasma Consumables electrode, nozzle, shield, swirl ring, inner cap, retaining cap, water tube, torch body, such as HT4400, HPR400XD, HPR260XD, HPR130XD, HPR260, HPR130, HSD130, HD3070, HD4070, HT2000, MAX200, POWERMAX1650, POWERMAX1250, POWERMAX65, POWERMAX85, POWERMAX45, POWERMAX30 and so on. Hyperterhm Plasma Consumables, Hyperterhm plasma cutting accessories, Hyperterhm plasma cutter parts, Hyperterhm plasma cutting consumables, Hyperterhm plasma cutter consumables, Hyperterhm plasma cutting tips, Hyperterhm plasma cutter tips, Hyperterhm plasma cutter tips and electrodes, Hyperterhm plasma cutting electrode, Hyperterhm plasma machine torch, Hyperterhm plasma cutting torch, Hyperterhm plasma torch parts, Hyperterhm Plasma cutter Swirl Ring, Hyperterhm plasma cutter nozzle, Hyperterhm plasma cutting nozzle.
 
 

 

 
 
 
Technical Support:

Safety operation procedure for plasma cutting machine

A, the use of the former and the cutting

1 should check and confirm the power supply, air source, water leakage, leakage, leakage, grounding or zero safe and reliable.

2 car, the workpiece should be in the appropriate location, and should be suitable for the workpiece and the cutting of the positive electrode, cutting the work surface should be provided with the dissolution of slag pit.

3 according to the workpiece material, the type and thickness of the selected nozzle diameter, internal shrinkage adjustment cutting power supply, gas flow rate and electrode.

4 automatic cutting trolley should be empty by far, and the selected cutting speed.

5 operators must wear protective masks, gloves, hats, electric membrane anti-dust masks and soundproof earmuffs. Without a protective mirror, the personnel of the plasma arc is strictly prohibited, and the exposed skin is strictly prohibited to be close to the plasma arc.

6 when cutting, the operator should stand on the upper hand. From the lower part of a work bench ventilation, and should reduce the operating table of the open area.

. cutting, when no-load voltage is too high, should be check the electrical grounding, the insulation connected zero and the torch hand, should be working table and the ground insulation, or in the electric control system installation no-load open circuit breaker.

8 high frequency generator shall be provided with shielding, high frequency arc, high frequency circuit should be cut off immediately.

9 the use of thorium and tungsten electrodes shall be in accordance with the provisions of article 12.7.8 of the JGJ33-2001.