SUMMIT Elevator Load Weighing Device 2000kg RHP-G-OMS-560 Over Load Control Device

SUMMIT Split type elevator load weighing device rated load installed at the rope hitch point over load control device
Installation location: installed at wire rope hitch point :OMS-560-RHP-G-2T(rated load: 2000kg)

 
Description: 

The elevator over load control device OMS-560-RHP-G is one kind of split type load weighing solution ,and it consists of 1 or 2 pressure load sensor RHP-F and a controller OMS-560, and the pressure load cell is typically plated under the wire rope hitch plate. This method have no impact on the crossing height requirements and are there-fore especially suitable for new installation and modernization projects.
Features:

1. Cost efficient and precise method
2. Very easy to install
3. Static load at fixing point(under the plate of wire rope attachment)
4. Suitable for the new installations and modernization project
5. Menu-guided operation
6. 5 relays output overload,full,half empty,optical, audio output
7. DIN Rail or on flat surface mounting with screws
8. IP-65 rated plastic box.
9. Integrated software to correct weight increases due to compensating chain.
10. Display load as well as percentage
11. Protecting important data from being disturbed by password
12. Automatic correction of zero drift, makes the equipment in optimum stage
13. Self-learning function, regulating high floor additional weight error
14. Control equipment swap entirely,self-diagnosis and alarming
15. Self-learning operating conducted by any fixed load

 
Wiring Diagram:

4 blank wires:

Installation location&Size:


 
Instruction:
The purpose of the SUMMIT Load Weighing system is to measure the load in the elevator and pro-vide usable information about the load to the elevator controller. This information is used forpre-torquing and for dispatching decisions, e.g. light load anti-nuisance, heavy load and over-load.
The system usually consists of a sensor or group of sensors mounted on the elevator’s some position such as clamping on wire rope, or under cabin, under the wire rope plate installation and a control unit. The sensor(s) provide a signal to the control unit directly related to the amount of load in the cab. The load weighing control accepts this signal and provides usable data to the elevator controller in the form of an analog signal and discrete relay contacts.