Flexo Corrugated Box Printing Machine , Rotary Die Machine Low Noise

Corrugated Box Flexo Printing Rotary Die Cutting Machine For Good Condition

Summarize

1. Each unit of the whole machine is equipped with an emergency stop switch, which can stop the electric movement of the unit at each part,

Ensure the safety of internal operators

Note: the movement of each unit of the machine is driven by the paper feeding group.

2. The electrical appliances of the whole machine are all famous brands at home and abroad, and the printing and die-cutting phases are zero,

Pre adjustment and fine adjustment.

3. The main motor adopts AC variable frequency speed regulation.

4. Each unit adopts independent electric control unit, which is safe and reliable.

5. Indicator light, relay, button, contactor, air switch, etc. shall be Schneider and Chint.

6. The frequency converter adopts the products of Shenzhen yingweiteng.

7. PLC and touch screen adopt Taiwan Yonghong.

Function configuration

Paper feeding Department

1. The main control panel is operated by touch screen and control button, convenient and reliable.

2. The start-up of the host is controlled by two buttons to ensure the safety of the operator and the host.

3. Continuous or interleaved feed (with counter) (can be selected or interleaved as required).

4. Set the paper feed count to display the production quantity.

5. The position of the left and right baffles is controlled by mechanical electric control.

6. Adjust the gap of front baffle synchronously and manually.

Printing Department

Digital control of each printing group

1. The outer diameter of printing plate roller is ф 393mm (including the outer diameter of plate thickness is ф 405mm).

2. The printing roller is made of high quality thick wall seamless steel pipe, and the surface is finely ground and plated with hard chromium.

3. Make balance correction, and run smoothly.

4. Scroll hanging plate, single side locking, making hanging plate alignment accurate, convenient and fast.

5. The whole plate hanging ditch is applicable to 10 mm plate hanging strip.

6. When loading and unloading the printing plate, it is convenient and flexible to use the foot switch to control the forward and reverse directions electrically, and the axle is provided with a disc.

Die cutting part

Operation function

1. Under the condition of no die cutting, the template roll and the high-strength rubber roll are automatically separated by the cylinder eccentric device, which can reduce the no-load load of the machine and prolong the service life of the high-strength rubber and the knife die.

2. Planetary gear type structure, the same as the printing department.

3. The die-cutting phase adopts electric digital 360 ° adjustment (operation and stop can be adjusted).

4. The machine is equipped with an excellent glue correction device, which can be used after repeatedly correcting the cots.

Technical Data