Hydraulic Automatic Single Head Heavy Material Rack Sheet Metal Decoiler Uncoiler

Hydraulic Automatic Single Head Heavy Material Rack Sheet Metal Decoiler Uncoiler

CNC Servo Feeder Structure

1). High quality, no electricity: Brush servo motor, effectively adjust the pitch, shorten the test time.

2). With high sensitivity decoder, the feedback is accurate, and then the feeding accuracy is within + 0.02mm.

3). Equipped with timing belt drive, it can eliminate backlash, wear very little, no noise, even no lubrication, safety and environmental protection.

4). The use of built-in motor units can be avoided when transporting and handling damage.

5). Available types: Hydraulic uncoiler, mandrel uncoiler

6). Hydraulic expansion and hydraulic drive system

7). Simple operation

8). Applicable to precoated steel coil, cold rolled steel coil and galvanized steel coil

Optional Device

1. Adjustable leveling/straightener speed

2. Adjustable machine according customer''s material requirement

3. Installation a press arm for heavy-thick material

4. Optional oil expansion or pneumatic expansion

5. Motor can be controlled by variable speed or frequency converter

Technical Parameter of Metal Sheet Material Heavy Decoiler

Remark: We als can according to customers requirements design non-standard material rack

Other Material Rack Single-head Light Decoiler Uncoiler Technical Parameters

Product Application

(1) Automatic operation
The rotation of decoiler uncoiler is controlled by automatic loop arm. The loop arm controls variable speed operation, providing smooth stop and start. Variable speed reduced uncoiler.
(2) Safety
Decoiler uncoiler rotation drive system and mandrel expansion power are fully protected. The pendant control allows automatic rotation to be disabled during coil loading.
(3) Electrical requirements
According to customer country requirements
(4) Architecture
The structure consists of steel plates and heavy structural sections. The seam is sealed and welded. Include structural supports as necessary. The expansion and contraction of the mandrel are realized by a connecting rod system including bronze bearings.
(5) Decoiler finish
After manufacturing, uncoiler frame shall be machine cleaned and powder coated before mechanical and electrical assembly.
(6) Coil car options
Can include reels with weights matching the specified uncoiler. The coil car consists of a "V" shaped surface with a central coil in motion. The coiler car includes sufficient vertical travel to contact the lower surface of the mandrel when fully extended. The power take-up car moves along the rail installed in the base of the uncoiler. The hydraulic check valve prevents the coil from falling vertically in case of hydraulic loss.
(7) Installation
Uncoilers and reels can be installed by drilling holes in typical industrial concrete foundations and concrete expansion bolts.