Auto Lubrication Turret Milling Machine NT40 Spindle Taper 5 HP Spindle Motor

Auto Lubrication Turret Milling Machine NT40 Spindle Taper 5 HP Spindle Motor
 
 
Taesin Turret Milling Machine Introduction:
      Taesin Turret Milling Machine can be used in the tool and die making industry, and also used to produce a wide range of spare parts or components in the manufacturing industry. It can do flat surface machining, indexing, gear cutting etc. 
     When do machining, the milling machine remove the metal by using a rotating cutter rotating on the workpiece. By feeding the workpiece againstt he rotating cutting, the milling machine can do cutting. The cutting is influenced by some elements, for example, the spindle speed, table feed rate, cutting depth, and the rotating direction of the cutter. But we can use some technics to make a good balance between these elements.
     The cutting efficiency is influenced by the depth of cut. The deeper the cut, the fast the production rate. At the same time, it is also effected by the strength of the cutter and workpiece hardness. Considering these factors, operators should consult the milling machine company for best advice. 
 
 
Taesin Turret Milling Machine Technical Characteristics:

• Strong Milling head from Taiwan

• Auto Lubrication and Coolant Device

• The working table and guide rail are heating treated and precision grinding.

• Grinding on slideways of column

• Table face hardened and ground

• Hardened and ground spindle gear.

• Dynamically Balanced Motor and Ground Pulleys.

• Chrome-Plated and Bearing Supported Motor Shaft Provides An Extremely Smooth, Low Vibration Quiet Drive.

• High Precision Spindles Use Class 7 Angular Contact Bearings.

• The Dovetail and Square Slideways of The Table

• The hard chrome quill is ground to mirror finish to ensure smooth movement.

• Z Direct Drive Connection between the motor and spindle

• XYZ Servo Motor

• X Travel 980mm

• Taiwai SYNTEC CNC System

 
The correct way to do clamping in the Turret Milling Machine:
 To ensure that each surface of the rectangular block is perpendicular to its neighbouring surfaces, the following points should be noted:-
• The vice jaws and the workpiece must be free from burrs, chips, and cutting
fluid.
• Smaller workpiece should be supported by parallel bars to provide the
supporting datum.
• Round bar must be placed between the workpiece and the movable jaw to
ensure that the workpiece is in perfect contact with the fix jaw.
• The vice handle should be tightened by hand to avoid over clamping of the
workpiece as well as the vice. Hide face hammer should be used to assure
that the workpiece is in perfect contact with the supporting base.
• On completion of the milling of the first face, the workpiece should be
unloaded, deburred, and cleaned before the next operation.
• To machine the second and the third faces, the workpiece should be clamped
with its preceding machined surface facing against the fix jaw of the vice.
• Similar clamping method can be applied in the machining of the fourth face.
• Yet it can also be clamped on the vice without the round bar.
• Both ends of the workpiece can be machined with the periphery flutes of the
cutter using up cut milling as shown in figure below
 
 
Turret Milling Machine Technical Data: