Home Companies Anterwell Technology Ltd.

Standard CMOS Process AP89341 Integrated Circuit Chip High Performance

Anterwell Technology Ltd.
Active Member

Contact Us

[China] country

Address: Room 36B1-B2, Building C, Electronics Science & Technology Building Shennan Mid-Road, Shenzhen China

Contact name:Sharon Yang

Inquir Now

Anterwell Technology Ltd.

Standard CMOS Process AP89341 Integrated Circuit Chip High Performance

Country/Region china
City & Province shenzhen guangdong
Categories Rubber Product Making Machinery Parts
InquireNow

Product Details

 

Standard CMOS process  aP89341/170/085

 

FEATURES

· Standard CMOS process.

· Embedded 8M/4M/2M EPROM.

· 341/170/85 sec Voice Length at 6KHz sampling and 4-bit ADPCM compression.

· Maximum 254 voice groups.

· Combination of voice blocks to extend playback duration.

· 7680 table entries are available for voice block combinations.

· User selectable PCM or ADPCM data compression

· Three triggering modes are available (controlled by M1 and M0 input pins):

           - Key Trigger Mode (M1=0, M0=0) - S1 ~ S8 to trigger up to 32 voice groups; SBT to trigger up to 254 voice               groups sequentially.

           - CPU Parallel Trigger Mode (M1=0, M0=1) – S[8:1] services as 8-bits address to trigger up to 254 voice                   groups with SBT goes HIGH to strobe the address bits.  

           - CPU Serial Command Mode (M1=1, M0=0) – user commands are clocked serially into the chip which                     enable user to fully control the operation of the chip.

· Voice Group Trigger Options: Edge / Level; Hold / Un-hold; Retrigger / Non-retrigger.

· Whole Chip Options: Ramp / No-ramp; Output Options; Long / Short debounce time.

· Optional 16ms or 65us (@ 8KHz sampling rate) selectable debounce time

· RST pin set to HIGH to stop the playback at once

· Three user programmable outputs for STOP pulse, BUSY signal and flashing LED.

· Built-in oscillator to control sampling frequency with an external resistor

· 2.2V – 3.6V single power supply and < 5uA low stand-by current

· PWM Vout1 and Vout2 drive speaker directly

· D/A COUT pin drives speaker through an external BJT

· Development System support voice compilation.

 

DESCRIPTION

aP89341/170/085 series high performance Voice OTP is fabricated with Standard CMOS process with embedded 8M/4M/2M bits EPROM. It can store up to 341/170/85 sec voice message with 4-bit ADPCM compression at 6KHz sampling rate. 8-bit PCM is also available as user selectable option. Three trigger modes, simple Key trigger mode, Parallel CPU trigger mode and CPU serial command mode, facilitate different user interface. User selectable triggering and output signal options provide maximum flexibility to various applications. Built-in resistor controlled oscillator, 8-bit current mode D/A output and PWM direct speaker driving output minimize the number of external components. PC controlled programmer and developing software are available.

 

 

PIN NAMES

 PIN (24-pin)  Playback Mode OTP Program Mode                Description
       1         S7            IO6  Trigger pin (I/O pin with internal pull-down)
       2         S8            IO7  Trigger pin (I/O pin with internal pull-down)
       3         VSS            VSS  Ground
       4         VOUT1             --  PWM output to drive speaker directly
       5         VOUT2             --  PWM output to drive speaker directly
       6         VDD            VDD  Supply voltage
       7         AVDD          AVDD  Analog supply voltage
       8         VPP            VPP  Supply voltage for OTP programming
       9         OSC          ACLK  Oscillator input
      10         COUT             --  D/A current output
      11         AVSS           AVSS  Analog ground
      12         OUT3            --  Programmable output (I/O pin)
      13         OUT2           SIO  Programmable output (I/O pin)
      14         OUT1           OEB  Programmable output (I/O pin)
      15          RST           DCLK  Reset pin (input pin with internal pull-down)
      16          SBT           PGM  Trigger pin (I/O pin with internal pull-down)
      17           M1             M1  Mode select pin 1 (input with internal pull-down)
      18           M0             M0  Mode select pin 0 (input with internal pull-down)
  19 ~ 24         S1~S6          IO0~IO5  Trigger input (I/O pin with internal pull-down)

 

 

VOICE SECTION COMBINATIONS

Voice files created by the PC base developing system are stored in the built-in EPROM of the aP89341/170/085 chip as a number of fixed length Voice Blocks. Voice Blocks are then selected and grouped into Voice Groups for playback. Up to 254 Voice Groups are allowed. A Voice Block Table is used to store the information of combinations of Voice Blocks and then group them together to form Voice Group.

 

                  Chip                                              aP89341                            aP89170                             aP89085
  Memory size                                                 8M bits                               4M bits                                2M bits
  Max no. of Voice Block                                 2016                                   992                                     480
  Max. no. of Voice Group                               254                                     254                                     254
  No of Voice Table entries                             7680                                   7680                                   7680
  Voice Length (@ 6KHz 4-bit ADPCM)         341 sec                             170 sec                              85 sec

 

Hot Products

TL7702A, TL7705A, TL7709A, TL7712A, TL7715A SUPPLY-VOLTAGE SUPERVISORS Power-On Reset Generator ...
TUSB3410 USB TO SERIAL PORT CONTROLLER 1.Controller Description The TUSB3410 provides bridging ...
256 x 256 DIGITAL SWITCHING MATRIX M3488B1 . 256 INPUT AND 256 OUTPUT CHANNEL CMOS DIGITAL SWITCHING ...
LF147/LF347 Wide Bandwidth Quad JFET Input Operational Amplifiers General Description The LF147 is a ...
FEATURES • Output capability: standard • ICC category: flip-flop GENERAL DESCRIPTION The 74HC/HCT107 ...
Features „ ♦ARM7TDMI-S processor, running at up to 72 MHz. „ ♦Up to 512 kB on-chip Flash Program ...