Shijiazhuang Zhongtai Pipe Technology Development Co., Ltd |
|
Shear & end welder parallel cuts the head of the strip coming out of uncoiler and the tail of the strip steel going into the accumulator, and weld them together to form a smooth and continuous line of strip steel.
1. Adopt oblique shear; Two down knives should be fixed on the down
knife base. The base is connected to the frame with screws. The up
knife should be installed on the moving frame. There is an oil tank
to move for up knife support frame.
2. Tighten; The position should be on the frame. Make two strips to
keep the level and press; Tighten the position to make right and
left parts; It can be controlled the air cylinder by footswitch.
3. To butt joint of right and left two pieces of the strip,
clamping the middle of copper electrode plates by clamping device;
The welding torch should be fixed on the moving slider, It can be
drive by screw shaft.
4. The screw shaft drive by the motor; The motor can be adjusted
speed by the inverter output frequency, then adjust the speed of
the welding torch.
5. The indicator is light for right and left, it shows pressing
tightly. on the contrary, it sends the materials.
6. It can be controlled by a footswitch for right and left tight;
The device will be a move for foot action.
7. The shear footswitch is in the middle; The up knife will cut
down for pressing the switch; Then the up knife will be back for
loosening the switch.
8. Adjust method: arc strike at edge 1-2.5mm; arc failure at edge
0.5-4mm.
9. Motorized button: there are front and back buttons; it can be
adjusted the welding torch position by hand.Position by the
indicator.
Shear & Butt Welding Types for Your Choice | |||
Type | shearType | centering Type | welding Type |
Manual shear&manual welding | Manual | Manual | Manual |
Hydraulic shear&manual welding | Hydraulic | Manual | Manual |
Hydraulic shear &auto welding | Hydraulic | Manual | Automatic |
Automatic shear& welding | Automatic | Automatic | Automatic |
Q: Are you a manufacturer?
A: Yes, we are a manufacturer. We have 4 factories ( Machining,
Assembling, Heat treatment, and Moulding ). We also have our own
R&D department. Welcome to visit us.
Q: What kind of payment term do you do?
A: We do T/T.
Q: What info do you need before giving me the price and proposal?
A: Since we design individual machines based on our customer's
requirements, we need your desired products' basic dimensions,
including all the pipe diameter(or tube length), thickness range,
usage, raw material steel grade, coil weight, and degree of
automation.
Q: What should I do if I just start a new business?
A: Contact us immediately, we provide a free consultant for
pre-sales service. Also, we can help you solve the raw material
(steel coil) purchase, worker training, international market price,
and more.
Q: How do you do QA?
A: We have a special team to do strict QA, this is one of our
strengths:
(1)Every gearbox will be tested for 8 hours with oil inside to
guarantee there is no leak.