Active Member
|
[China]
Contact name:
Shijiazhuang Shiza Pump Industry Co.,Ltd. |
|
|
Changeable Anti Corrosive A05 Ultra Chrome Volute 100ZGB Sludge Pump Wear Parts
When it comes to pumping abrasive slurries it`s not a question of if you will need spare and wear parts – it`s a question of when. This parts is Volute Liner E4110A05, completely replace with spare parts. With fully integrated systems and single source supply solutions we simplify the inventory, distribution and installation of spares and wears to keep our customers` processes running longer, safer and more efficiently.
The above shown spare parts are High chrome pump parts. The parts are made of 26-28% high chrome metallurgy has a guaranteed HRC58+ hardness. Variety of metallurgies are available for more corrosive applications.
Pump parts
pump Casing
Split outer casing design with cast or ductile iron with the
wearing liners , which can provide high operating pressure
capabilities.
2. Impeller
The impeller may be either molded elastomer or hard metal.
Cast-iron impeller threads are better suited for slurries.
3. Interchangeable Hard Metal and Moulded Elastomer Liners
4. Mating faces in hard metal liners are tapered to allow positive
alignment during assembly and allow components to be easily removed
or replacement.
5. Impeller The impeller may be either molded elastomer or hard
metal. Cast-iron impeller threads are better suited for slurries
| Type | Code | Mark | Mechanism Performance | Special Performance | Application | ||
| HRC | |||||||
| δw/δb | αk | ||||||
| MPa | J/cm2 | ||||||
| Anti-wear white iron | A05 | KmTBCr27 | ≥700 | 6--10 | ≥56 | Erode resistance is a little bit lower than A07 with certain corrosive resistance | Used for higher wear condition with PH between 5 and 12 |
| A07 | KmTBCr15Mo | ≥550 | 4--8 | ≥59 | Best erode resistance but lower wear resistance than A05 | Used for higher wear condition | |
| A01 | KmTBCr8 | ≥550 | 6--8 | ≥55 | The erode resistance is about 0.9 times of A05. | Used for mud pump | |
| A11 | KmTBMnMo | ≥400 | 3--6 | 38-42 | Lighter erode resistance and lower hardness. It can be perforated and tapped. | Used for light wear condition with fine grain. | |
| Anti- wear &anti-corrosive iron | A49 | -- | ≥600 | -- | 43 | It has certain erode and corrosive resistance in low PH condition. Its wear resistance is nearly equal to A03 | For lower PH condition,especially for flue gas. For low sour condition desulphuration installation (PH≥4) |
| A33 | -- | -- | -- | 35 | It has certain erode and corrosive resistance that is similar to A03 and certain corrosive resistance. | It can transport oxygenated slurry with PH not be less than 1. | |
| Anti-wear cast steel | A22 | -- | 1200 | -- | 45 | Fine anti-erode & anti-corrosive, high hardness. | Used for dredge pump casing. |
| A23 | -- | 700 | -- | HB500-600 | Higher hardness and anti-erode. | Used for anti-wear &corrosive and high erode condition. | |
| A25 | -- | -- | -- | HB300-350 | Lower hardness, better anti-wear & anti-corrosive and weldable. | Used for light erode and wear condition. | |
es.6. Hydraulic seal rings give positive sealing between mating faces.
