16M Bit CMOS Serial Flash Memory IC Electrical Component MX25L6405DMI-12G

MX25L6405DMI-12G 16M-BIT [x 1 / x 2] CMOS SERIAL FLASH MEMORY

GENERAL DESCRIPTION

The MX25L1605D are 16,777,216 bit serial Flash memory, which is configured as 2,097,152 x 8 internally. When it is in

two I/O read mode, the structure becomes 8,388,608 bits x 2. The MX25L3205D are 33,554,432 bit serial Flash memory,

which is configured as 4,194,304 x 8 internally. When it is in two I/O read mode, the structure becomes 16,772,216 bits

x 2. The MX25L6405D are 67,108,864 bit serial Flash memory, which is configured as 8,388,608 x 8 internally. When it

is in two I/O read mode, the structure becomes 33,554,432 bits x 2. (please refer to the "Two I/O Read mode" section).

The MX25L1605D/3205D/6405D feature a serial peripheral interface and software protocol allowing operation on a simple

3-wire bus. The three bus signals are a clock input (SCLK), a serial data input (SI), and a serial data output (SO). Serial

access to the device is enabled by CS# input.

When it is in two I/O read mode, the SI pin and SO pin become SIO0 pin and SIO1 pin for address/dummy bits input and

data output.

The MX25L1605D/3205D/6405D provides sequential read operation on whole chip.

After program/erase command is issued, auto program/ erase algorithms which program/ erase and verify the specified

page or sector/block locations will be executed. Program command is executed on byte basis, or page (256 bytes) basis,

or word basis for Continuously program mode, and erase command is executes on sector (4K-byte), or block (64K-byte),

or whole chip basis