Home Companies Qingdao Golden Shark Yacht Technology Co., Ltd.

3700GPH 24v Dc Submersible marine foot Boat Water Pump Electric

Active Member

Contact Us

[China]

Address: Shandong Qingdao

Contact name:Eric Zhang

Qingdao Golden Shark Yacht Technology Co., Ltd.

3700GPH 24v Dc Submersible marine foot Boat Water Pump Electric

Country/Region	china
City & Province	qingdao shandong
Categories	Pumps

Product Details

3700 GPH 24v 12v Dc Boat Marine Submersible Bilge Water Pump For Yacht

Non-automatic bilge pumps offer traditional operation activated by a float or panel switch. Removal of the motor cartridge allows for easy cleaning of the strainer and impeller in the event that the pump becomes clogged with debris. Electric Submersible Pumps are by far the most popular type of electric Bilge Pumps, submersibles give very high outputs, and cost effective, have low amp draw and are easy to install. They are designed to fit in the lowest part of the bilge and only require discharge pipe work and electricity supply. Also can be used in other applications like transfer river water, work together with solar panel or battery.

Meets or exceeds RoHS, SGS, and ISO standards Traditional operation by switch or float switch Compact, efficient, long life motors 110°F (43°C) temperature limits Easy clean snap-lock strainer bases Anti-Airlock protection Run dry capable for normal workloads Exclusive moisture tight seals Completely submersible Marine grade blocked wiring Stainless steel shaft Silent and vibrationless operation

SYMPTOM	POSSIBLE CAUSE	CURE
Reduced Flow	Plugged strainer	Clean outside of strainer and clean debris from around impeller.
	Discharge line plugged	Clean out hose by backflushing.
	Low battery voltage	Check battery condition and charge if necessary.
	Kinked discharge hose	If hose is kinked because of sharp bend , convert to hose which will not kink at bends.
No water pumped	Wire connections	Make sure wire connections are not corroded . Visual check is not enough -a slight pull on each wire will tell if the wires are still joined .Check to be sure on wire joins are hanging down into the water .
	Fuse meited	Check fuse to see that it is the correct size if fuse still blows ,check impeller through inlet opening to be sure it is not jammed or stuck with debris.
	Float switch failure	Lift end of float switch up-if pump runs , switch is OK . If pump does not run , turn Manual SWITCH TO on position-if pump runs ,automatic switch has failed.
Pump won't shut off	Something under float	Clean under the float to make sure debris is not holding the float up.
	Stuck float	Chenk to see that the float is loose and free of gummy bilge oil. If float action appears sluggish and / or the float does not move freely , intermittent or sporadic operation of the pump may occur . This condition is usually the result of oil and / or Dirt accumulating in and around the movable parts of the switch . To corrent , try soaking the entire switch in Marine cleaner for ten minutes , agitating several times and checking for smooth and free operation of the float . Repeat if necessary.
	Switch mounted too low	If the pump is sucking air and the automatic switch has not reached the OFF position , then the switch may be mounted too low for the pump and should be reinstalled at least 1/4 higher than the pump base.
Wires over-heated. Melted insulation	Combination of jammed impeller and wrong size fuse	Be sure impeller is clean of debris and is free to rotate . Reduce fuse to propei size .Replace damaged wiring and / or switch .
Repeated melted	Fuse size or jammed impeller	Be sure fuse has amp rating . Check impeller to see that it is not bound up by fish line . ETC.

1. Are you a manufacturer ?
Yes,We specialize in different kinds of 12V/24V DC water pump such as diaphragm pump,marine pump,RV pump,drinking water pump,gear pump etc and electric sprayers for over 15 years with excellent quality and competitive price.
2. What's your MOQ ?
Normally it is 100PCS, but we also accept samples for new costumers to test .
3.Do you accept OEM / ODM ?
Yes , we have different customers make their own OEM product. We also can make products as per your requirement .
4. What about the delivery time ?
Usually we can ship your orders within 15-30 days from receipt your 30% deposit .
5.What's your payment terms ?
T/T 30% in advance,70% balance against B/L copy.
6. Can I buy different types in one container ?
Yes, you can mix different types in one container.
7. What is your port of loading ?
Fuzhou Port,Xiamen Port or Ningbo Port .
8.What is your warranty ?
We offer 12 months limited Warranty of Manufacturer for defective items (excluding items damaged and/or misused after receipt ) .
9. Why you find some price on our items show only 1-20USD/PCS, can you get the price at USD1.0 ?
1-20USD is just price range for your reference here.
10.Do you have some discount ?
To clients who bring repeat orders and large orders.Please contact us for the Best Quote.