Active Member
|
[China]
Address: No.388 Heping Road, Xinxiang City, Henan Province,China
Contact name:Emily
Xinxiang jinrui machinery factory |
|
|
This Sidewall belt conveyor with corrugated shield, in particular
applied in conveying material in big inclination, for it with
corrugated shield and horizontal clapboard belt. And it can widely
used in coal, metallurgy, chemical industry, light industry,
petroleum, port, mechanical etc to convey all kinds of bulk
materials and the piece.
Density of handled bulk materials 500~2500kg/m3, max inclination is
90°, max lump size is 550mm, lump of handled should depends on belt
width, belt speed, clapboard height and inclination.
Ambient temperature generally -25~+40℃, material temperature to be
handled should be under 50℃. It should take other measures for
special requirement such as heat resistant, proof cold, resistant
retard, resistant acid and alkali, resistant abrasion, proof
explosion, proof water etc.
Maximum utilization of space – able to convey material at angles up to 90 degree, able to instead of bucket elevator.
Low power requirement, low cost, long service life and quiet smooth
running.
Remarks: the below capacity is based on coal and speed 1m/s to caculated for reference.
| Bandwidth | 1000mm | ||||||||
| Cleats hight | 160mm | 200mm | 240mm | ||||||
| Pitch of cleats | 126mm | 376mm | 252mm | 378mm | 504mm | 252mm | 378mm | 504mm | |
| Slop | 30 degree | 186 t/h | 129 t/h | - | 207 t/h | 159 t/h | - | 283 t/h | 229 t/h |
| 40 degree | 150 t/h | 99 t/h | - | 160 t/h | 122 t/h | - | 231 t/h | 176 t/h | |
| 50 degree | 120 t/h | 79 t/h | 79 t/h | 112 t/h | - | - | 185 t/h | 141 t/h | |
| 60 degree | 98 t/h | 64 t/h | 64 t/h | 105 t/h | - | 229 t/h | 151 t/h | - | |
| 70 degree | 80 t/h | 52 t/h | 52 t/h | 85 t/h | - | 287 t/h | 123 t/h | - | |
| 90 degree | 49 t/h | - | - | 52 t/h | - | 115 t/h | 76 t/h | - | |
Belt conveyors are not allowed to overload run.
All safe alarming should be in good condition.
Check wear condition of the belt, the damaged should be repaired.
Operators should circuit to inspect to close observe belt conveyor
running. Especially,temperature rise and noise of main motor and
the brake working whether they are normal; contact state of the
brake and oil level, noise of gear unit and run off of belt should
be noticed;temperature rise and noise of all bearings and state of
all transition loads point should be noticed;
notice to see whether the hopper are blocked, working state of
pulley, idler, belt cleaner, take-ups and control equipment.
Operators should make good record if any abnormal. The belt conveyor should be stoppe on emergency.
Periodic overall: Minor overall should be once every monthes besides ordinary maintenance Overhaul should be once half past year or once every year.
