Active Member
|
[China]
Address: Room707, Jude Commercial Building, South Zhengfeng Road, Fuyong town, Baoan District, Shenzhen, Guangdong, China
Contact name:Alan Chang
Shenzhen Mingyang Digital Technology Co.,Ltd |
|
|
2000W Hot Air Seaming Machine / Heat Welding Machine
Product Description :
When picture size more than printer printing width, need to split the picture to some part, after print out then weld them together.
Usually use 502 glue to joint them by hand, but this way is disadvantageous, like:
♦ slowly
♦ after long time the glue is not hard
♦ the glue will dirty picture
♦ work by hand hard to control the quality etc
But , Our banner welder-B can resolve the problem successfully.
♦ It is use for weld split PVC, PE and other material can be hot melt .
♦ Use Leister heat resister, it is long life
♦ With long handle, no need keep squat during welding
♦ Has laser positioning function.
Easy to operation , step as below :
1). Before hemming or welding, leave 30-40mm wide overlap edge for connection the two disjunct surface pieces, immobilize both ends of each disjunct pieces with something such as stick belt or clamp.
2). Turn on the power, according to quality and thickness of the PVC banner, consider the ground circumstance, set the proper termperature and speed, adjust the suitable hot-air blowing rate, wait for machine hot up around 2 minutes.
3). Bring up the machine, place the rubber wheel at the end of the overlap edge.
4). Turn the handle to left down, insert the welder nozzle into the gap of two overlap pieces, then the machine will moving and seaming automatic.
5). During welding, use the long handle to align the moving direction, let the upper piece edge be in touch with the inner side of the welder nozzle.
6). After the machine go pass the overlap edge to the end, the two disjunct pieces will be joined together, then turn the welder handle to right, it will stop moving.
7). Turn off the heater switch, wait the gun come to cold, then turn off the power supply is ok
Operation Notice:
♦ To prolong the electrothermal heater, after work it is strongly advice that cooling the heater at first, then turn off the power 5 minutes later. In case of the power suddenly be off, should handle the welding gun away firstly, and close down the temperature knob, nextly consider the problem of power supply.
♦ To get better satisfied bonding effect, the ground of the overlap pieces should be smoothly, hard and heat resistive. We suggest that the operator may do some more test and practice using some samples of the pieces to get the suitable speed and temperature and hot-air blowing rate before operate it for seaming formally.
| More details : |
| Welding width : 2-4cm |
| Welding Thickness : 0.2-2mm |
| Welding power : 1600W |
| Welding Voltage : 110V/220V |
| Welding Speed : 5-15m/min |
| Welding Temperature : 20-500 degree |
| Welding air gun : Leister hot air gun |
| Welder wheel : Aluminum wheel |
| Welding Frequency : 50-60HZ |
| Is handle : Yes |
| Welder cable : 10 meters |
| Welding use : hot air (no need glue ) |
| Welder warranty : 1 year |
We assure you :
Sale the best quality Banner Welding Machine to you
Offer the best price to you
Arrange the fast delivery to you
Provide good after-sales service
Please send your Inquiry Details at the below , Thank you so much !
