ABB Module CI630 3BSE011000R1 ABB CI630 Foundation Fieldbus long life

ABB Module CI630 3BSE011000R1 ABB CI630 Foundation Fieldbus long life

Product Description:

I/O configuration Module 07 DC 92 does not store configuration data. The 32 configurable channels are defined by the user program as inputs or outputs, which means that through reading and writing data in the user program, each configurable input/output channel can be used as input, output, or rereadable
output.Normal operation The module automatically initializes after the power has been switched on. During that time, all LEDs are switched on. When the CS31 system bus does not run, LED 3 flashes.
LED 3 goes out again when the bus operation runs correctly and the module does not recognize an
error.The 32 yellow LEDs 1 show the signal status of the 32 channels.

Related Product Recommendation:

Product's Character:

An address must be set for each module to enable the central unit to correctly access the inputs and outputs.A detailed description about "Addressing" can be found in the chapter "Addressing" for the central processing unit and coupler.The address setting is accomplished with the DIL switch located under the slide cover on the right side of the module housing.When using cental units 07 KR 91 or 07 KT 9x as bus
master, the following possibilities (address assignments)are offered, depending on the setting of the address DIL switch  Item n in the table designates the module address that can be set with the address DIL switch with switches 2...7. When using 07 KR 91 / 07 KT 9x as bus master, we recommend to use even-numbered module addresses (08,10, 12......60).In this setting, (DIL switch 1 in OFF position = factory setting) the module occupies two addresses for inputs and outputs.

The use of the product: