CPV+CCV Antigen Combo Rapid Test
(Feces/Vomit)
REF VIPC-627
INTENDED USE
The CPV + CCV Antigen Combo Rapid Test (Feces/Vomit) is a sandwich
lateral flow immunochromatographic assay for the qualitative
detection of Canine Parvovirus antigen and Canine Coronavirus
antigen in dog’s feces or vomit.
For veterinary use only.
PRINCIPLE
The CPV + CCV Antigen Combo Rapid Test (Feces/Vomit) is based on
sandwich lateral flow immunochromatographic assay. The test has
testing windows with an invisible T (test) zone and C (control)
zone in each. During testing, the liquid will laterally flow on the
surface of the test strip. If there is enough CPV antigen or CCV
antigen in the sample, a visible T line will appear in the
corresponding region. The C line should always appear after a
sample is applied, indicating a valid result. By this means, the
test can accurately indicate the presence of CPV antigen or CCV
antigen in the sample.
STORAGE AND STABILITY
Store as packaged in the sealed pouch either at room temperature or
refrigerated (2-30 °C). The test is stable through the expiration
date printed on the sealed pouch. The test must remain in the
sealed pouch until use. DO NOT FREEZE. Do not use beyond the
expiration date.
PRECAUTIONS
Do not use after the expiration date. Do not reuse the test kit.
Handle all specimens as if they contain infectious agents.
Observe established precautions against microbiological hazards
throughout testing and follow the standard procedures for proper
disposal of specimens.
Wear disposable gloves and eye protection when specimens are
being tested.
Humidity and temperature can adversely affect results.
Do not remove test cassette from its pouch until immediately
before use.
Do not mix components from different lot and different products.
Please ensure that an appropriate amount of samples are used for
testing. Too much or too little sample size may lead to deviation
of results.
MATERIALS
Materials Provided
• Test Cups (with dilution buffer)
• Swabs
• Package Insert
Materials Required But Not Provided
• Timer
DIRECTIONS FOR USE
Allow the test snd specimen to equilibrate to room temperature
(15-30 °C) prior to testing.
1. Remove the test from the foil pouch and use it as soon as
possible. Best results will be obtained if the assay is performed
within one hour.
2. Unscrew the cap of the test cup.
Collect dog's vomit with a swab or collect dog's feces with a swab
from dog's anus. Insert the wet swab into the test cup and mix
well. Remove the swab.
Collect dog’s feces with the collection applicator on the ground.
Randomly stab the specimen collection applicator into the specimen
in at least 3 different sites to collect approximately 50 mg of
feces (equivalent to 1/4 of a pea). Do not scoop the fecal
specimen.
3. Insert the specimen collection applicator back into the test cup
and tighten the cap.
4. Shake the test cup for about 10-15 seconds to mix well. Leave
the cup for reaction for 2 minutes.
5. Remove the plastic limit strip of the test cup.
6. Put the test cup on a clean and level surface, press the cup
body from the top to the bottom and start the timer.
Note: Keep the test upright while testing. Do not move or turn the
test upside down.
7. Read the result at 5-10 minutes. Do not interpret results after
15 minutes.
