|
[China]
Trade Verify
Address: Room 2102 ,South building , intersection of Fuqiang Street and Huailing road ,Yuhua district ,shijiazhuang city ,hebei province
Contact name:Alisa
Hebei Xingkuan wire mesh Tech co .,ltd |
|
Verified Suppliers
|
|
|
U-shaped metal sheet horseshoe chain mesh belt for River cleaning
and Garbage disposal
Descriptions :
Stainless Steel Horseshoe Chain Mesh Belt is made of pivots and metal sheets. The two ends of the pivot are welded. For some specifications , the ends of the pivot can also be seamed. The width of the mesh belt is determined by the mesh belt specifications and the number of odd holes. Flat Wire Belt requires very little maintenance work, and if used properly, it has a long lifespan. The materials of Flat Wire Belts are carbon steel, galvanized steel, 304 and 316 stainless steel.
Quick Detail :
| Product Name | Horseshoe chain mesh belt for conveyor machine |
| Certificate | SGS |
| Technique | Flat Wire Conveyor Belts |
| Material | 201,304,316L,310S,410 etc |
| Specification | Rod diameter: 3 mm to 8mm. Spiral pitch: 12.7 mm to 70 mm. Rod pitch: 25.4 mm, 31.75 mm, 38.1 mm, 50.8 mm, 63.5 mm, 76.2 mm. Flat strip thickness:1.2mm,1.6mm,2mm Belt width: 200 mm to 6,000 mm. |
| Size | Max width can reach to 6000mm , belt length can be customized as your machine. |
| Other services | Special requirements can be customized |
Proper sprocket location is essential for smooth belt operation. Sprocket teeth must always drive against the connector rods. This accomplished by locating the DRIVE sprockets so that the teeth are in the odd numbered openings and locating the tail sprockets so that the teeth are in the even numbered openings.
The drive shaft must be perpendicular to the belt and the drive shaft and infeed sprocket must be parallel. 6. After making sure the conveyor is cleared off and the drive sprockets are moving the belt in the correct direction, run the conveyor. Tension the belt with the infeed take-up.
The following hints on belt operation will help avoid any problems with your wire mesh belt conveyor:
A. Observe direction of belt travel as shown in the drawings
provided in this manual.
B. Loading should be evenly distributed across the full width of
the belt.
C. Unloading of the belt should be positive. Loads should not be
held stationary while
the belt is running.
D. Belt should not be started or stopped when fully loaded.
E. Keep the belt and conveyor clean so that product cannot jam the
belt or get
between the sprockets and belt
Applications :
Notice :
CUSTOMERIZED BELT , WE WELCOME YOU .
