Portable Air Cooled UV LED Curing Equipment

Portable Air-Cooled UVLED Curing Equipment

Product advantages
1. It has beautiful appearance, light volume and space saving.
2. Wide application, reliable quality, safe use and convenient operation
3. Easy to operate, one key switch

4. Fast curing speed, improve production efficiency
5. The advanced heat dissipation system automatically controls the heat dissipation time

to ensure that the workpiece is not affected by temperature and prolong the service life of the lamp.

Precautions
1. Please read the instructions carefully before using the small UVLED curing machine;
2. Do not look directly at the UV lamp and the light source for a long time, otherwise it will burn your eyes;
3. High voltage electricity danger;

4. When repairing and replacing parts, please turn off the main power supply. Replace the UV lamp tube,

please discharge the stored electricity of the capacitor;

5. Do not put your hands on the transmission part to avoid danger;
6. When testing the machine, check whether the phase sequence of the fan is correct.
UV machine product repair and maintenance

1. In order to prolong the service life of UVLED equipment and ensure the normal operation of the equipment,

the equipment should be inspected before starting up, and the problems should be corrected in time.
2. Start running continuously for half an hour. Observe whether the indicators and indicators are normal,

and whether there is any abnormal sound during operation. If abnormalities are found, check immediately.

3. Clean the panel at least once a month and check whether the screws of each part are loose.
4. Avoid touching the lamp tube with your hands to prevent sweat and oil from affecting the ultraviolet light transmission.

If it is accidentally contaminated, it can be wiped clean with alcohol cotton.
5. The lamp and reflector should be wiped with alcohol once a month to keep them clean. If the surrounding

environment is bad, increase the number of cleanings accordingly.

6. The exhaust fan should be cleaned every three months to clean the fan blades, the outside of the casing and

the appearance of the motor.
7. Add lubricating oil to each rotating part of the fan, adjust the air valve drive mechanism, tighten each terminal,

and check whether the air valve drive mechanism is flexible and reliable, and whether the wires are damaged.

8. If the small UV curing machine is not used for a long time, it is advisable to loosen the conveyor belt to

make it in a free state.
9. After a period of use, the transmission chain will naturally extend and should be adjusted in time. During the

use of the conveyor belt, due to temperature changes, there may be deviations, and should be adjusted in time.

10. Guarantee the lubrication of the movable parts of the small UVLED curing machine. The active and passive

rollers, bearings, chains and transmission wheels should be greased every six months; other parts and motors

should be greased once a year.
11. After each use of the small uv curing machine, clean up the dirt and dust to ensure that the mesh belt runs freely.

12. Frequently check whether the plug of the small uv curing machine is in good contact with the socket. For example,

when the price of the small uv curing machine is running normally, if the cable is found to be hot and hot, we must stop it.

13. The electrical wiring inside the machine must not be changed at will. In the event of a malfunction, check and

repair in time, and non-professional maintenance personnel are not allowed to disassemble or replace it without authorization.