5000589 888 Renault 50mm Truck Propeller Shaft

Support Center Bearing 50 00 589 888 5000589 888 for Renault 50mm

High Quality Spare Part Hanger Bearing 5000819211 12568011457 fits RVI 370 RENLT

How to ensure the reliable operation of bearings

Generally speaking, pay attention to the following points from the perspective of use:

1. The bearing clearance should be appropriate, too large will cause impact, too small will cause poor lubrication, and may burn bushes;
2. The surface quality and geometry of bearings and journals should be strictly guaranteed;
3. Improve lubrication quality, control oil pressure, temperature and flow, and strengthen oil filtration;
4. Use fuel and lubricating oil that meet the requirements.

In order to give full play to the bearing and maintain its due performance for a long time, it is necessary to do regular maintenance (regular inspection). Through appropriate regular inspections, it is very important to improve productivity and economy to detect faults early and prevent accidents before they occur.

How to keep the bearing

The bearings are coated with an appropriate amount of anti-rust oil and packed with anti-rust paper when they leave the factory. As long as the packaging is not damaged, the quality of the bearings will be guaranteed. However, for long-term storage, it is advisable to store it on a shelf 30cm above the ground under the condition that the humidity is lower than 65% and the temperature is about 20℃. In addition, the storage place should avoid direct sunlight or contact with cold walls.

From the perspective of use, to ensure that the bearing can work reliably, pay attention to the following points:

1. Improve the quality of lubrication, control the pressure, temperature and flow of the oil, and strengthen the oil filtration.

2. Use fuel and lubricating oil that meet the requirements.

3. To control the temperature status of diesel generator sets, it is disadvantageous to work under the conditions of over-cooling and over-heating. In cold weather, the diesel engine should be warmed up before starting, and the crankshaft should be turned by hand to make the oil enter the friction surface.

4. The surface quality and geometry of bearings and journals should be strictly guaranteed.

5. The bearing clearance should be proper. If the generator set is too large, it will produce impact. If it is too small, the lubrication will be poor and the bushing may be burnt.

Image description