Jining Qinfeng Machinery Hardwae Co., Ltd. |
Verified Suppliers
|
Lathe Machine Tool Holder CAT Face Milling Cutter cat tool holder
To cut a CAT face milling holder, you will need the following tools
and materials:
- CAT face milling holder
- Cutting tool (such as a hacksaw or bandsaw)
- Bench vise
- File or grinder
- Safety goggles
- Work gloves
Here are the steps to cut a CAT face milling holder:
1. Put on your safety goggles and work gloves to protect yourself
from any flying debris.
2. Secure the CAT face milling holder in a bench vise, ensuring
that it is clamped tightly and securely.
3. Determine the desired length of the CAT face milling holder and
mark it with a marker or scribe. Make sure to measure carefully to
ensure an accurate cut.
4. Using a cutting tool such as a hacksaw or bandsaw, carefully cut
the CAT face milling holder along the marked line. Apply steady and
even pressure to ensure a clean and straight cut.
5. After cutting, remove the CAT face milling holder from the vise
and inspect the cut edge. If there are any rough or uneven edges,
use a file or grinder to smooth them out. This will help ensure a
proper fit and prevent any potential issues during use.
6. Once you are satisfied with the cut and the edges are smooth,
clean off any debris or metal shavings from the CAT face milling
holder.
7. Your CAT face milling holder is now ready to be used. Make sure
to follow the manufacturer's instructions and guidelines for proper
installation and usage.
Remember to always exercise caution when working with cutting tools
and machinery. If you are unsure or uncomfortable with cutting the
CAT face milling holder yourself, it is recommended to seek
assistance from a professional or someone with experience in
metalworking.
Model | D1 | L1 | H1 | C1 | W1 |
CAT40-FMA25.4-1.75 | 25.4 | 1.75 | 17.5 | 2.362 | 9.5 |
CAT40-FMA31.75-2 | 31.75 | 2 | 17.5 | 2.756 | 12.7 |
CAT40-FMA38.1-2 | 38.1 | 2 | 23.8 | 3.346 | 15.9 |
20CrMnTi Material CAT40 FMB32 Face Milling Tool Holder ,the cutter bar clamping tungsten steel mold bar, the need to comply with all kinds of tool rod device description of. In order to avoid clamping precision caused by improper, distortion.CAT Face Milling Holder used in the clamping of the cutter with the radial drive groove, such as the face milling cutter, the vertical disc cutter, the set type end mill, high speed and high precision machining .
CAT Face Milling Holder Specifications
1. CAT Face Milling Holder material:20CrMnTi
2. CAT Face Milling Holder hardness:56-58
3. CAT Face Milling Holder precision taper less than AT3
4. carbon depth less than0.8mm
5. CAT Face Milling Holder pre-balance standard:G6.3
18000rpm,precision balance G2.520000rpm,25000rpm,30000rpm
6. Surface"environment protection",special coating surface
treatment,improve the hardness and endurance of the
surface,cleaness better,accuracy stable,surface
CAT Face Milling Holder The positive benefit:
* to shorten the processing time, increase production per unit of
time.
* the overall product precision, appearance quality.
* the production cost can be reduced.
CAT Face Milling Holder Customer trust, under the orders of the
chip increase