Tungsten Carbide Tricone Roller Bit , Rock Drill Bit Run Quickly API Standards

API Standards Rock Drilling With Tungsten Carbide Insert Tools For Mining Industry

Click here for catalogueTCI DRILL BIT.pdf

Click here to know how to select bits ABOUT IADC.pdf

IADC 5 SERIES DRILL BITS

The soft formation TCI tricone bits are used to drill low compressive strength, very soft formations.

This bit maximized to use of both conical and chisel tungsten carbide inserts of large diameters and high projection.

This cutting structure design, combined with maximum cone offset, results in high bit penetration rates.

The deep intermesh of cutter rows prevents bit bailing in sticky formations.

Common fault analysis of Tricone bits

1. Early wear of the shirttail

Fault description: Abrasive formations, bent drill rod, seriously worn stabilizer and insufficient air for drilling rate attained etc, are all the causes which result in premature shirttail wear. In this case, the configuration of cones is good and the amount of inserts wear is small. Shairttail wear can also allow the big roller bearings to fall out resulting in bit failure.

Method: The designer should strength the shirttail with certain measures to increase the wear-resistance capacity of shirttails.

2. Early wear and loose movement of the bearing

Fault description: Excessive weight on bit, insufficent air to clean the hole and/or cool the bearing, leads to bearings overheating due to improper cooling and poor cuttings removal can shorten the service life of bit bearing.

Method: Reduce bit pressure and increase air pressure.

3. Cutting structure failure

Fault description: Excessive WOB or Rotation speed; Wrong bit selection; Cuttings blowing in bad conditions caused repeating crushing.

Method: Correctly select operating parameters and rotary types for specific working conditions

Advantage:

1. Strictly select the material to ensure the reliable quality. Bad steel and tungsten carbide inserts won't be used.

2. Strictly act according to the ISO9001 standard, and control by full-scale inspection.

3. Sales and support people are highly trained in the latest rock drilling technology and can offer you expert advice on what products will best fit a specific end use application.

Bits thread are manufactured according to API standards.

Quality Control

1, Raw material selection:To make a good drill bit, it is necessary to select the best material and gatekeeping the quality of the material. We purchase the high-quality steel and strictly control the material composition and size, it main includes the detection of the shape, diameter, reamed diameter, length composition, and flaw of the raw material, Tungsten Carbide and Grease are also the best raw materials on the market.Besides, we marked every different piece of materials before transferred to the warehouse.

2, In strict accordance with the ISO9001 international standards for production.

Carefully control every step of the production, complete each of the production process,

the production process is including blanking, forging, rough turning, heat treatment,fine turning, quenching, assembling, welding, painting, then storage.

Each working process was full inspected, after the qualification, then move to next working process, which to ensure the 100% qualified rate.

Main Products We Provide

We mainly provide Tricone Bits(TCI Drill Bits) for open pit mining.

a). Type: Tungsten Carbide Insert (TCI)

b). Formation Application: Soft to Hard Formation

c). Size Available: 7 7/8''~26''

d). Popular IADC Code: IADC545,645,725,735,745,825,835

Don’t see the bit you are looking for? Give us a call, we can customize any bit to fit your unique circumstances.

The above represents commonly available sizes and types, we do produce other sizes and types of rock drill bits which do not appear on . Please contact us for more information.