Hot Rolled Stainless Steel Plate 310 / 310S / 310H Heat Resistant Steel Plates Laser Cutting

Grade 310, 310S, 310H

Grade 310 (UNS S31000) and its various subgrades combine excellent high temperature properties with good ductility and weldability.

Grade 310H (UNS S31009) has a carbon content restricted to exclude the lower end of the 310 range, so is the grade of choice for high temperature applications.

Grade 310S (UNS S31008) is used when the application environment involves moist corrodents in a temperature range lower than that which is normally considered "high temperature" service. The lower carbon content of 310S does reduce its high temperature strength compared to 310H.

Grade 310L is a series of proprietary grades, generally with a 0.03% maximum carbon and sometimes used for very specific corrosive environments such as urea production.

Like other austenitic grades the 310 family have excellent toughness, even down to cryogenic temperatures, although other grades are normally used in sub-zero environments.

Corrosion Resistance

The high chromium content - intended to increase high temperature properties – also gives these grades good aqueous corrosion resistance. The PRE is approximately 25, and sea water

resistance about 22°C, similar to that of Grade 316. In high temperature service they exhibit good resistance to oxidising and carburising atmospheres. Resist fuming nitric acid at room temperature and fused nitrates up to 425°C.

The high carbon contents of all except 310L do make these grades susceptible to sensitisation and hence intergranular corrosion after elevated temperature exposure or welding.

310 is subject to stress corrosion cracking but more resistant than Grades 304 or 316.

Heat Resistance

310H has good resistance to oxidation in intermittent service in air at temperatures up to 1040°C and 1150°C in continuous service. Good resistance to thermal fatigue and cyclic heating. Widely used where sulphur dioxide gas is encountered at elevated temperatures. Continuous use in 425- 860°C range not recommended due to carbide precipitation, if subsequent aqueous corrosion

resistance is needed, but it often performs well in temperatures fluctuating above and below this range. Prone to sigma phase embrittlement in the temperature range 650 – 900°C.

Grade 310H is generally used at temperatures starting from about 800 or 900°C - above the temperatures at which 304H and 321 are effective.

Heat Treatment

Solution Treatment (Annealing)

Heat to 1040-1150°C and cool rapidly for maximum corrosion resistance. This treatment

is also recommended to restore ductility after each 1000 hours of service above 650°C, due to long term precipitation of brittle sigma phase.

These grades cannot be hardened by thermal treatment.

Welding

Good characteristics suited to all standard methods. Grade 310S electrodes generally

recommended for fusion welding. AS 1554.6 pre-qualifies welding of 310 with Grade 310 rods or electrodes.

“Dual Certification”

310H and 310S are often produced in "Dual Certified" form – mainly in plate and pipe. These items have chemical and mechanical properties complying with both 310H and 310S specifications.

Product complying with 310 only or dual certified 310 and 310S may have a carbon content below 0.04% which will not be acceptable for some high temperature applications.

Typical Applications

Furnace parts. Oil burner parts. Carburising boxes. Heat Treatment baskets and jigs. Heat exchangers. Welding filler wire and electrodes.

Specified Properties

These properties are specified for flat rolled product (plate, sheet and coil) in ASTM A240/A240M (310S and 310H) and ASTM A167 (310). Similar but not necessarily identical properties are

specified for other products such as pipe and bar in their respective specifications.

Composition Specification (%) (Single values are maxima)

Mechanical Property Specification