Active Member
|
[China]
Address: 88 Century Dadao, Pudong New Area, Shanghai, China
Contact name:Zhang
DZ Iron Steel Group |
|
|
Aluminium Coil Grade 3003 H24 For Food Container
Aluminum 3003 h24 properties
| Aluminum Alloy 3003 may be a non-heat-treatable 1.2% manganese,
0.12% copper alloy commonly available in flat rolled coil, sheet
and plate from a good range of manufacturing mills. it's one among
the foremost commonly used of all aluminium alloys, essentially
commercially pure aluminium with the addition of manganese to
extend its strength about 20%. it's all the superb properties of
alloy 1100; excellent corrosion resistance plus the power to be
easily drawn or spun, welded or brazed. Alloy 3003 is fairly low
strength but it are often hardened to a big degree by cold
working,enabling a series of“H” tempers.Alloy 3003 is additionally
produced as a bright finish treadplate (also referred to as chequer
plate) with industrial and ornamental applications.The alloy is
additionally produced as drawn or extruded seamless tube, forgings,
wire and bar and foil; these forms are available on indent from
Atlas. Alloy 3003 is additionally available as an “Alclad”product
with one or each side clad in Alloy7072; again available on indent
from Atlas. Aluminum 3003 h24 Corrosion Resistance Excellent during a wide selection of atmospheric environments, in food and architectural applications. Aluminum 3003 h24 Heat Treatment Alloy 3003 isn't hardenable by heat treatment. It are often significantly hardened by cold work (eg by cold rolling) and various “H”tempers are produced – most ordinarily H12(¼ Hard) and H14 (½ Hard) – also as thesoft annealed Temper O condition.Alloy 3003 is typically supplied in H1x tempers,where the merchandise is strain hardened only;there is not any stabilisation treatment as is common for the 5xxx series alloys.To soften Alloy 3003 it are often annealed byheating to 415°C, hold until uniformtemperature then cool; the speed of cooling isnot important. Aluminum 3003 h24 Welding Excellent weldability by all standard methods;gas, electric and resistance welding. GMAW and GTAW are preferred and widely wont to produce structural welds. Filler alloys are usually 1100 although other alloys are possible. Welding of strain hardened tempers will reduce strengths within the heat affected zones. Aluminum 3003 h24 Machining Machinability of the softer tempers O and H12 is poor, with the harder tempers like H14 and above being somewhat easier to machine. Aluminum 3003 h24 Treadplate Treadplate in alloy 3003 is usually utilized in decorative architectural applications, thanks to its bright reflective finish. it's usually produced during a “1-bar” or “propeller” tread pattern. Alloy 3003 treadplate is out there on indent from Atlas. Aluminum 3003 h24 Typical Applications cooking utensils, decorative trim, awnings,siding, storage tanks, chemical equipment. |
Packaging & Shipping
1. Standard seaworthy exporting carton.
2. Wooden pallets on the bottom.
3. Waterproof plastic package.
4. Packing paper cover.
5. Or as required.
Size: Detailes will calculated when get your inquiry.
