Active Member
|
[China]
Address: 502, No. 31, Yangmei Road, Bantian Street, Shenzhen, Guangdong, China
Contact name:Emily Tan
SHENZHEN XISHEN DEVELOPMENT COMPANLY LIMITED |
|
|
Laser Distance Meter Range Finder Rangefinder 40m 60m 80m 100m
Caution:
1. Please avoid kids to use the meter.
2. Do not open the meter without allow from professional person.
3. Please keep the manual, it is useful when you use it.
Basic Functions
| Single Measurement | √ |
| Max. / Min. Measurement | √ |
| Continuous Measurement | √ |
| Area / Volume / Pythagoras | √ |
| Plus and Minus | √ |
| Meter/Ft/ln Switch | √ |
| Measuring Reference | √ |
| Buzzer Indicator | √ |
| Historical Data Records | 99Groups |
| Data Clean up | √ |
| Error Message Code | √ |
| Battery Indicator | √ |
| Digital Level (angle measuring) | √ |
| Laser Auto. Switch off | 30s |
| Instrument Auto. Switch off | 180s |
Technical Parameters
| Measuring Range | 0.05m~40m 0.05m~60m 0.05m~80m 0.05m~100m 0.05m~120m 0.05m~150m |
| Measuring Accuracy | ±1.5mm |
| Measuring Unit | m,ft,in |
| Laser type | 620~690nm |
| Laser Class | Ⅱclass,<1mW |
| Single Measurement Time | 0.25s |
| Operating Temperature | 0~+40 ℃ |
| Storage Temperature | -20~+65℃ |
| Batteries | AAA(Alkaline), 2x1.5V |
| Measurements Per Battery Set | >8000 |
| Weight (Without Batteries) | Approximately 82g |
| Dimensions(LxW×H) | 115X50X23mm |
Comment:
* The deviation occurs under unfavorable conditions such as bright
sunlight or when measuring too poorly reflecting or very rough
surfaces, the environment temperature is too high or too low.
* When measuring distance within 10m, measurement accuracy is±1.5mm; more than 10m, measurement accuracy is calculated as follows:±1.5mm±0.05*(D-10)(D: Measuring Distance, Unit: m)
Forbidden
1. Opening the equipment by using tools (screwdrivers,etc.) without
allow.
2. Measuring to sun.
3. Others measuring out of appointed range.
4. Immersing the equipment in water.
5. Cleaning the lens using alcohol or any other organic solvent.
6. Wiping the lens directly with fingers or other rough surfaces.
7. Powering the equipment beyond the rated DC voltage.
