GE FANUC SERIES 90-30 PLC Digital I/O Module IC697BEM713 FACTORY SEALED

GE FANUC SERIES 90-30 PLC Digital I/O Module IC697BEM713 FACTORY SEALED




Product Description:

GE Fanuc Discrete input module for 90 - 30 series PLC offers 16 input points with one common power input terminal. It requires an AC power source for convenient operation. Module has LED indicators at the top to offer ON/OFF status of each point. Module has circuit wiring information on the surface towards the inside and circuit identification information on the outside surface. Module has a voltage rating of 120 VAC at 50/60 Hz, 0 - 132 VAC at 50/60 Hz, input current rating of 12 milli-Amps and a power rating of 90 milli-Amps at 5 VDC. It has a maximum ON response time of 30 milli-seconds and maximum OFF response time of 45 milli-seconds. Module is compatible with input devices such as pushbuttons, limit switches and electronic proximity switches. Input/output module provides the interface between the PLC and external input devices such as proximity sensors, push buttons, switches and BCD thumbwheels. It supports different voltage ranges, types, current capacity, isolation and response time to meet your application.




Product Details:

Input modules provide the interface between the PLC and external input devices such as proximity sensors, push buttons, switches and BCD thumbwheels. Output modules provide the interface between the PLC and external output devices such as contactors, interposing relays, BCD displays and indicator lamps. This module requires an AC power source, it cannot be used with a DC power source.



 

Product Summary:

• Type of Device: Bus Controller Module 90/70 Transmitter
• Current Required from 5V Bus: 1.4 Amp
• Effective Data Rate: 500 Kbytes/sec
• Time to store 16 Kbyte program: 20 - 30 seconds
• Maximum cable length: 50 feet (15 meters)

• Description: Bus Transmitter
• Maximum cable length: 50 feet (15 meters)
• Product Description: The Bus Transmitter Module (BTM) permits expansion from the main CPU rack when more modules are required in a system than can be contained in the CPU rack. The BTM allows expansion from the CPU rack to a maximum of 7 additional IC697 PLC racks. It also provides a high performance parallel interface to the programming device. The module occupies a single slot and has two connectors. The top one is for attachment to the programming device. The bottom one is for a daisychained arrangement through Bus Receiver Modules to expansion racks. Three green LEDs provide status indication of each port and module status. The BTM must be configured into the IC697 PLC system using the MS-DOS or Windows programming software configuration function.
• Weight: 1.5 lbs