Shijiazhuang Gezi Screen Manufacturing Co.,Ltd |
|
60 Shore PU Screen Printing Squeegee G1 Flat 20mm * 9mm * 2650mm
Introduction:
1. Material
Most of them are made of PU material or natural rubber.
2. Compared PU material with natural rubber
The squeegee made of PU material is wear-resistant and practical. It coule be used for a long time. However, if used too long time, the printing effort is not so good.
3. Squeegee made of natural rubber, good elasticity, strong permeability, good printing effect, little damage to the conduction belt, but not wear-resistant, short use time
Spefication date sheet
50*9mm ,55*9mm,45*9mm,50*7mm,45*7mm,40*7mm, 55*5mm,50*5mm,45*5mm,40*5mm,35*5mm,25*5mm
Width(mm)*Thickness(mm) | Length(m/Roll) | Shore A(Hardness) |
50mm*9mm | 4m/roll | 65A-95A |
55mm*9mm | 4m/roll | 65A-95A |
45mm*9mm | 4m/roll | 65A-95A |
50mm*7mm | 4m/roll | 65A-95A |
45mm*7mm | 4m/roll | 65A-95A |
55mm*5mm | 4m/roll | 65A-95A |
50mm*5mm | 4m/roll | 65A-95A |
45mm*5mm | 4m/roll | 65A-95A |
40mm*5mm | 4m/roll | 65A-95A |
35mm*5mm | 4m/roll | 65A-95A |
25mm*5mm | 4m/roll | 65A-95A |
When choosing the appropriate performance of the squeegee, you need to consider the following factors
1. Hardness: The squeegee is usually made of polyurethane, and the
hardness of the squeegee is measured by a hardness tester.
The hardness, size and shape of the squeegee determine the
bendness, flexibility and pressure of the squeegee. The high
hardness of the squeegee is very beneficial for the first three
functions, pressing the ink into the screen and transferring the
ink from the fine screen to the substrate and maintaining contact
with the printed line. The only drawback is that it cannot meet the
printing of different shapes of substrates, and the requirements
for the quality of the squeegee are also high when printing rough
surfaces and uneven surfaces.
2. Effective width: refers to the width of the squeegee inserted
into the aluminum handle to extend the squeegee.
This width is important and determines the degree of curvature of
the squeegee under pressure. The degree of curvature is the cube of
the effective width.
Squeegee bending causes two changes: the direct angle change of the
squeegee and the screen; the printing pressure transmitted to the
substrate is reduced. For example, the scraper is compared to a set
of springs. When the spring is forced at a certain angle, the
spring begins to bend and the pressure is getting smaller and
smaller.
Contact person: Alice
Wechat/Whatsapp:8615100134172
Tag: PU Screen Printing Squeegee