High Strength And Mobility Self Leveling Polymer / Commercial Vinyl Flooring Compound

High Strength And Mobility Self Levelling Cement commercial vinyl sheet flooring Compound Accessories M530

Uses:

M530 high strength self-leveling, using special cement, fine aggregate and foreign brands of polymer spray powder resins and other raw materials such as cement additives, refined, with a high mobility, self-leveling high plasticity of the material foundation for heavy commercial buildings, industrial and other applications.

Construction Method:

①Subfloor clean, it should choose the appropriate primer, when the primer has been absorbed by the subfloor, start semi-state (approximately 2-6 hours after the primer construction), construction began leveling. ②Poured in a container of about 6.5 liters of water, and then slowly added a 25 kg bag of leveling with a stirrer and stirred until a uniform slurry without groups , pouring the mixture was uniformly spread , with special teeth scraper control the thickness of the mouth, just a good mix of construction to prevent direct sunlight and strong wind blowing, the mixture must complete construction within 20 minutes. ③Initial setting before leveling with anti-foaming rollers rolling ground to exclude when mixed into the air. ④Transmission capacity can be used up to 20-40 liters/minute self-leveling slurry pumping.

Primary Treatment:

Subfloor must be dry, solid, load-bearing, dust, debris hinder bonding, smooth surface. To ensure self-leveling surface strength and adhesion, water-based absorbent subfloor recommend using M318 primer. Stone, terrazzo base surface, tiles and other non-absorbent surface of the substrate, it is recommended to use M320 non-absorbent primer for processing.

Features:

Fast automatic leveling ground, fast-setting, low shrinkage

Construction can be freely controlled thickness

Construction thickness of 2-5mm, excellent compressive and flexural strength

Environmental protection

Note:

As the product contains cement, reacts with water to produce highly alkaline, avoid contact with skin, eyes; once contact, immediately flush with water; If skin or eye injury, seek immediate medical attention. This product will not produce the body, environmental impact material after hardening.

Packaging and Storage:

25kg composite bag. The product shall be kept indoors, pay attention to moisture, prevent freezing, exposure. Stacked on pallets no more than eight layers, the shelf life of six months.

Technical Parameters: