High pressure vertical pipeline booster pump

1. MAIN USES:

The booster pump apply to transport liquid whose impurity content is lower than 1% and the max particle size is smaller than 0.1mm, or whose chemical and physical characteristics is similar to clean water.

They are always used on daily-use and fire-emergence water for tall buildings. And they also can be used to supply water in mine, cities towns, companies and low pressure boiler. 

2. TYPE of Booster pump :

ISG:  High pressure vertical pipeline booster pump, vertical inline pump

3. TMPERATURE:

Up to 80Celsius Degree

ISG model booster pump is single-stage end-suction(axial suction) cantilever type centrifugal pump, which is used to transport corrosive liquid with viscosity similar to water and without solid particles. The marked and rated performances and dimensions adopt international standard.

It has such characteristics as wide range of performance, high efficiency, high mechanical, chemical and physical level and convenient maintenance etc. It is energy saving type product recommended by the nation with its efficiency being 5% greater than that of other similar model pump.

The temperature of transported media of ISG model High pressure vertical pipeline booster pump, vertical inline pump is -20 to 105 C deg . Through adopting cooling method, it can transport media with higher temperature if necessary, and is applied to transport various corrosive media or media in which pollution is forbidden similar to water in such industries as chemical industry, petroleum, metallurgy , electric power, papermaking, food, pharmacy and synthetic fiber etc.

Performance:

Tips for High pressure vertical pipeline booster pump, vertical inline pump installation
Please take note as below when install the pump:
1. The preformed hole on the foundation should be poured as the pump installation drawing.
2. The installation level should meet the demand of the allowed vacuum suction height. The foundation should be in horizontal and stable condition, to make sure the rotation of the driver machinery same with the pump in the direction.
3. When connect by coupling, must make sure the pump and driver shaft center should be in a straight line.
4. If belt connection, the shaft center should be in parallel.
5. The booster pump suction pipe should be sealed well, and try to less the quantity of the elbow and check valve. When fill water, exhausted the air. It should be no any air when operate. We need to keep the suction pipe slopes up slightly, and then connect with the pump inlet.