PLC Control Plastic Blow Moulding Machine Wide Mouth / Hot Fill Bottle

CM-A4 Full Automatic Blow Molding Machine Suitable For Wide-Mouth And Hot Fill bottle

Descriptions :

CM-A4 full automatic blow molding machine is suitable for producing PET plastic containers and bottles in all shapes. It’s widely used for producing the carbonated bottle, mineral water bottle, pesticide bottle, oil bottle, cosmetics bottle, wide-mouth bottle and hot fill bottle etc.

1. Stable performance with advanced PLC.

2. Automatic preform conveyor to save human cost.

3. Preform self-rotation and infrared pre-heater revolution assure the even distribution of heat which improve the bottle shaping rate, increase the production.

4. High adjusting performance to enable preheat the preforms perfectly by adjust the voltage control area in the PLC, which could adjust the temperature of the infrared lights in the pre-heater and keep the proper temperature and humidity invariable.

5. High safeties with security automatic-locking device in each mechanical action, which will make the production into a perfect safe environment, in case of the breakdown in certain procedure.

6. Introduce the FESTO air cylinder to avoid contamination and noise.

7. Satisfaction with different atmospheric pressure for blowing and mechanical action by dividing the blowing and action into three parts in the air pressure diagram of the machine.

8. Strong clamping force with high pressure and double crank links to lock the mould.

9. Two ways of operating : automatic and manual.

10. Not only safe but reliable and unique design of the position of valve to make the pneumatic diagram in the machine easier to understand.

11. Low cost, high efficiency, easy operation and maintenance etc. profited from the fully automatic technological process.

12. Ideal cooling system make the finished bottles without any flaws.

13. Easy install, test and start up.

14. Low rejection rate : less than 0.2 percent.