Ningbo Brando Hardware Co., Ltd |
Verified Suppliers
|
|
2'' CA50T000 CA50T010 CA50T001 Goyen Type Pulse Jet Valve
Keeping baghouse pulse jet valves in good working condition is key to maintaining efficiency in a dust collection system. Diaphragms within the pulse valves require regular replacement, usually every few years (depending on the application). Maintaining your baghouse’s pulse valves in good working order can have an enormous impact on the efficiency and operation of your system.
Brando supplies a full line of pulse valves and repair kits for all major pulse valve makes and models (including Goyen, Asco, Sbfec and Turbo). Generally, our replacement diaphragm repair kits are cheaper than those directly purchased from the original manufacture. We also carry solenoids (remote and integral) to fit all makes and models.
Technical data of Right Angle Pulse Jet Valves:
Model No | CA15T | CA20T | CA25T | CA35T | CA45T | CA50T | CA62T | CA76T |
Nonimal size | φ15 | φ20 | φ25 | φ35 | φ45 | φ50 | φ62 | φ76 |
Port Size | G1/2'' | G3/4'' | G1'' | G1 1/4'' | G1 1/2'' | G2'' | G2 1/2'' | G3'' |
Working pressure | 0.3 to 0.8MPa | |||||||
Temp. range | -5℃ to 55℃ | |||||||
Relative humidity | ≤85% | |||||||
Working medium | Compressed clean air | |||||||
Voltage | 24VDC, 220VAC |
Dimension of CA50T Goyen Type Pulse Jet Valve:
Video of CA50T Goyen Type Pulse Jet Valve:
Detail images of Goyen Type Pulse Jet Valves:
More Goyen Type Pulse Valve For You to Choose:
Threaded Type Immersion Type Dresser Nut Type Flanged Type
RCA Series Solenoid Coil Armature Assembly Pulse Controller
Installation:
1. Prepare supply and blowtube pipes to suit valve specification.
Avoid installing valves underneath the tank.
2. Ensure tank and pipes are free from dirt, rust or other
particulate.
3. Ensure supply air is clean and dry.
4. Mount valves to inlet pipes and blowtube to valves, ensuring no
excess thread sealant can enter the valve itself.
5. Make electrical connections to solenoid or connect RCA pilot
port to pilot valve (RCA valves only).
6. Apply moderate pressure to system and check for installation
leaks.
7. Fully pressurise system.
8. Test fire and listen for proper actuation and crisp pulse noise.
Focus on your demands, Offer you best solution:
√ Contact us if some points you have doubt
√ Contact us if somewhere need to change
√ Contact us if not the one you are looking for
√ Contact us if you are doing designing
Welcome to your any question and inquiry!