100kw Wannan Motor Plastic Bottle Recycling Machines

Waste PET Bottle Cutting ,Washing ,Drying Recycling machine line
 

 
Waste PET Bottle Cutting , Washing ,Drying Recycling machine
 

 
Machine photos for reference
 
1. Bale opener/De-baler is made up of Automatic lift and De-baler. The Automatic lift will convey the PET Bottle Bales to De-baler to break the bales to bulk bottles.
Adopt specialized hard face gearbox.
 

 
 
2. Belt conveyor + Label remover
 

 
2.1 Blade material is alloy steel, the blade teeth are replaceable. Design of Arc Knife, the space between Rotary blades and Stable blades will be always the same to avoid breaking the PET Bottle necklace while Rotary blades and Stable blades rotating at 360 degree (The necklace is the best part in the bottle, the viscosity is the highest )
the viscosity is the highest
 

 
2.2 There are limit switch installed on the inspecting hole. The machine will be stopped while opening the door, to keep sure safety producing
 
 

 
2.3 Designed of inspecting window for checking and maintainance the machine
 

 
3. Sorting table
 

3.1 With chutes to connect to crusher, to feed materials into crusher directly.
3.2 Equipped with hooks
3.3 With chutes and containers and a place for the supervisor at the end of the belt.
3.4 Handrail for the people not below 100cm measured from platform bottom
 
 
4. Crusher
 

 
4.1 Blades frame The blade of plastic bottle crusher using claw structure which with strong adhesion for hollow thin-wall products and sheet
 

 
 
4.2 Blade material can be customized: 9CrSi ( Russia material),SKD-11 (Japan Material), D2 etc.
4.3 Crusher open Adopt Hydraulic open. It can be opened and closed easily to allow changing of blades to improve the working efficiency
 

 
5. Steam washer
Hot washing for removing glue, oil, dirty. There are special design for discharging PP/PE labels and caps.
The steam washer1 is designed deep enough for separating PP/PE Labels/cap from PET; The depth of steam washer 2 is lower than steam washer because most PP/PE Labels/caps is discharged by Steam washer 1
 

• With quantitative feeder for chemical detergent
• Adopt Asbestos for insulation layer, thickness is 40mm

 
6. Floating washer
6.1 For Separating PET from PP/PE Caps and Labels;
6.2 Removing the dust and dirty after the High speed friction washer
(Because of the property of the plastic -- PP/PE will be floating on the water; PET will be down in the water)
6.3To middle PH Value
 

 
 
7. High speed friction washer
For removing the dirty on the surface of the flake
 

 
 
7.1 With the design of dirty water dewatering. To keep water clean on the next step washing processing. Enlonger the water using
7.2 Adopt NSK bearing
7.3 Rotating speed 1200rpm
7.4 With the Americal wearing material on the surface of the screw blades for longer working life

 
8. Horizontal dewatering machine ----Final moisture can be 1.8%
 

 
8.1 Adopt European standard belt wheel and SKF Bearing
 

 
8.2 Adopt Americal wearing material to enlonger the working life of screw
 

 
9. Label separator/Zigzag separator to separate PP/PE Labels from PET Flake and remove plastic powder