Pneumatic Duct Isolation Dampers Customized Color Motorised Type For Industry

Pneumatic ISOLATION damper CUSTOMIZED Color MOTORISED type for INDUSTRY

Product description

1. The isolation door is designed with a fully enclosed structure. After the plug plate is opened, it is located in an airtight maintenance room on the other side.

2. The plugboard adopts a dedicated whole plate, and the sealing surface of the plugboard is processed by milling chips, with small sealing gap and good sealing performance.

3. The connection method between isolation door and field pipe can be flange bolt connection, insert anti-flange welding or pipe direct butt welding connection.

4. The pneumatic isolation door is driven by the opening and closing pneumatic device to rotate the screw pair and produce axial movement. Then, through the guide drive screw sleeve, the plug board is driven to move, and the plug board is pulled out or pushed into the plug board.

5. The pneumatic isolation door is inserted into the housing by the opening and closing cylinder to pull or push the opening or closing of the plug plate.

6. The electric (pneumatic) isolation door opens or closes. By means of the sliding roller installed on the two sides of the board, the board is limited to operate in the rail.

7. Isolation door can be operated from a distance or controlled by a program, with DCS remote control interface.The electric isolation door is equipped with electromechanical electric device, which can be operated locally and remotely, and equipped with handwheel operating mechanism.Pneumatic isolation door matching cylinder and control box, can be in place and far control operation.

Classification

1.According to performance, it can be divided into round shut-off door, round regulating door, square shut-off door and square regulating door.

2.The driving method is cylinder drive

3.According to the manufacturing process, it can be divided into single-layer sliding door and double sliding door.

4, according to the material can be divided into cast iron round damper, carbon steel round damper, stainless steel round damper and rare earth wear-resistant round damper.

Features

1. The overall heat treatment of the equipment, no deformation under large temperature differences, the use of novel sealing materials, good sealing performance, high wear resistance.

2. Optimize the design, make the thermal insulation door reduce the accumulation of dust on the guide rail during use, reduce the failure rate, reduce the maintenance cost and the labor intensity of the maintenance staff.

Techinal parameters

1. Model: A (length) * B (width) * H (height)

Note: A * B can be a variety of air ducts such as rectangles and circles, which are determined by the user. H damper thickness is generally 560mm.

2. Medium: cold and hot air.

3. Design temperature: ≤400 ℃.

4. Withstand pressure: ≤30Kpa.

5. The technical parameters of this product can be customized according to the special requirements of users.